If you wire up the connector, it has "guides" on it that will only mate with the ?BITX connector the right way. The schematic also shows the connections.

Jack, W8TEE

On Thursday, July 11, 2019, 9:58:27 AM EDT, V Zecchinelli <n1vin@...> wrote:

I see.? Thank you.? So pinout is as below?
JackAl? J11??? ??? ??? uBITx Audio
1??? ??? ??? ??? ??? ??? ??? 4
6 - 5-4-3??? ??? ??? ??? 6
2??? ??? ??? ??? ??? ??? ??? 5
Thanks,
Vince

On 7/11/2019 8:58 AM, jjpurdum via Groups.Io wrote:

The Audio Connector is detailed in the wireup instructions on the hfsignals.com site, step 4.1:

Our connector simply replaces the one above. The connection from the JackAl cable harness to the ?BITX pot is also explained there.

Jack, W8TEE

On Thursday, July 11, 2019, 6:24:33 AM EDT, V Zecchinelli <n1vin@...> wrote:

Sorry Jack.? You would think after 40 years of sending engineering reports from the field that I would pay more attention to detail.
This pic is from Assembly Manual V16 ODT file.? The IDC connector "To JackAl J11" to "uBITx Audio Connector" and "uBITx Pot"? that is unclear.

On 7/10/2019 9:24 PM, jjpurdum via Groups.Io wrote:

Are you talking about the wiring harness assembly? I have attached it in case you have not seen it.

Jack, W8TEE

On Wednesday, July 10, 2019, 2:06:20 PM EDT, V Zecchinelli <n1vin@...> wrote:

Good afternoon,
Reading through old messages I know everyone involved is busy and being pulled in several directions.? Is there someone who has successfully installed the Jackal PCB who would email me a couple of pics of their audio wiring harness.? Particularily the 2X3 IDC connector end and the volume pot end.? I think I could make a wild guess but with the time and money I have invested to this point I would hate to blow something up.
Thanks,
73 Vince N1VIN