开云体育

All: Since our web site is still contaminated, I have uploaded the library file to this web site in the Files section. Jack, W8TEE

Where can we get the RA8875 Library when the Hamradiodesign site is compromised?

For some reason, it's beginning to sound like the EEPROM is not getting written to. See what the EEPROM debug functions return which I mention in another post. Jack, W8TEE

Dave: JackAl maintains a list of two sets of EEPROM values. They are referenced by the symbolic constants EEPROMDEFAULTOFFSET and EEPROMUSEROFFSET. Around line 980 in the JackAl.ino file, you will

how do i read the eeprom values for the screen.? maybe the values are not getting written properly? and how do i make the serial port work. i have not been able to see anything on it. dave

no it is a 5 inch dave

Dave, Are you using the 7” screen? Asking because I have the same problem with my screen which is a 7”. And after running for bit touch response gets worse and ultimately stops responding. Also

That looks reasonable. let me talk with Al tomorrow. Jack, W8TEE

attached is a screen shot of the radio in calibration mode.? 4 times around. ? checking again it appears that the touch part is compressed from both sides.? if i fiddle with it i can make most of

The new calibration routine requires you to press firmly on each dot and will not let you move to the next one until it gets a good reading. You should do at least 3 "complete cycles around the

That is the latest... Jack, W8TEE

should the calibration have taken that long or longer also with each step? dave

v.96

No, it should respond in less than a second and all of those button should be active, so something's still amiss. What version of the software are you running? Jack, W8TEE

We're going to take it down and start all over. Just not sure when...As I said earlier, for now stay away. Most of the relevant files are posted in the Files section of the group. Jack, W8TEE

Very irrritating Dennis

jack or others that might have the answers i got the touch screen to work( miswired) and ran the calibration routine but now it appears that the calibration is not right. have run the calibration

In the second section of the jackAl manual, you'll find the description of J4 As you can see, pins 7 and 8 are tied together, as are pins 3 and 4. Both of these are GND connections on J4. Jack, W8TEE

I'll be receiving a couple of test boards this weekend. will advise how things work. N2AIE

Jack / AL, could you confirm that you have 2 wires going to the same pin on the attached image? Thanks. vince n2aie