Re: touch screen
|
That looks reasonable. let me talk with Al tomorrow. Jack, W8TEE
On Thursday, May 9, 2019, 5:20:00 PM EDT, k7da <k7da@...> wrote:
attached is a screen shot of the radio in calibration mode.? 4 times around. ? checking again it appears that the touch part is compressed from both sides.? if i fiddle with it i can make most of the buttons work with some difficulty. dave
On 5/9/2019 1:03 PM, jjpurdum via
Groups.Io wrote:
The new calibration routine requires you to press firmly on
each dot and will not let you move to the next one until it
gets a good reading. You should do at least 3 "complete cycles
around the screen" before you exit the calibration routine.
After that's done the key values are stored in EEPROM and used
on the next reboot.
Jack, W8TEE
On Thursday, May 9, 2019, 12:59:19 PM PDT, k7da
<k7da@...> wrote:
should the calibration have taken that long or longer
also with each step? dave On
5/9/2019 12:41 PM, jjpurdum via Groups.Io wrote:
No, it should respond in less than a second and
all of those button should be active, so something's
still amiss. What version of the software are you
running?
Jack, W8TEE
On Thursday, May 9, 2019, 3:01:45 PM EDT, k7da
<k7da@...>
wrote:
jack or others that might have the
answers
i got the touch screen to work(
miswired) and ran the calibration
routine but now it appears that the
calibration is not right. have run
the calibration several times with
the same results.
the buttons do not respond as i
thought they should.? if i press the
1800 key i get the 1500 instead.?
the top line of red buttons do not
work at all.? the other side on the
display seems to work though.
should the response time be 2-3 sec
thanks dave k7da
|
jjpurdum