I need the PA load capacitor for the SR-2000.

C156 3 section Halli. Part #048-000629.

I think someone else had the same need a short time ago. I cannot find the topic in the archives. Hope someone remembers the outcome or has a parts unit.

A majority of acceptance is not proof of correctness.

I got lucky. Simple fix. When I got the load cap out, I could clearly?see the rotor was too far to the rear. I adjusted the end play screw and centered the rotor plates and all is fine. That is when I notice that the lock tight seal was only on the retainer nut and did not cover the adjustment screw. I think I will drill a hole in the rear plate to allow access to that adjustment.

A majority of acceptance is not proof of correctness.

Wow. Awesome.? ?I tried that on mine but the plates where badly scorched.? Also, If you are not aware, You should run a wire from the rear section TOP terminal to the rear section bottom terminal.? Use teflon wire or HV wire if you have a piece.? Jim told me this would prevent the terminal from being damaged on the one side of the cap.

C