Wow. Awesome.? ?I tried that on mine but the plates where badly scorched.? Also, If you are not aware, You should run a wire from the rear section TOP terminal to the rear section bottom terminal.? Use teflon wire or HV wire if you have a piece.? Jim told me
this would prevent the terminal from being damaged on the one side of the cap.
C
toggle quoted message
Show quoted text
From: Walt Cates <cateswa@...>
Sent: Friday, June 7, 2024 11:31 AM
To: clark clarkturnertuning.com <clark@...>
Cc: HALLI IO GROUP <[email protected]>
Subject: SR-2000 load cap
?
I got lucky. Simple fix. When I got the load cap out, I could clearly?see the rotor was too far to the rear. I adjusted the end play screw and centered the rotor plates and all is fine. That is when I notice that the lock tight seal was only on the retainer
nut and did not cover the adjustment screw. I think I will drill a hole in the rear plate to allow access to that adjustment.
Walt Cates, WD0GOF
?
A majority of acceptance is not proof of correctness.
