¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. HallicraftersRadios
  2. Topics

3 gang Variable cap needed

 
Edited

Got one?? The bearings fell out of this one on the SR2000.??

C
 
Edited


600 Pcs Metric Precision Steel Bearing Balls, Assorted Stainless Steel Loose Bicycle Bearing Steel Balls, Meal Bearing Steel Ball Assortment Kit, 2/2.5/3/3.5/4/4.5/5/5.5/6/7/8/9/10 mm




Good Luck
wa3gin


On Tue, Mar 26, 2024 at 3:42?PM W7WRX <clark@...> wrote:
Got one?? The bearings fell out of this one on the SR2000.??

C

 

If they are ball bearings you may be able to get new ones from a
hardware store. If you have any of the originals you can use them to
determine the size needed.


On 3/26/2024 12:42 PM, W7WRX wrote:
Got one?? The bearings fell out of this one on the SR2000.

C
--
Richard Knoppow
Los Angeles
WB6KBL
SKCC 19998
 

I ordered the balls off Amazon.? Good idea.? Not sure how to get them in there but they must have come out!

I also found a replacement cap on Ebay. Looks very similar.? Will get that on its way also.

Thanks!!
 
Edited

McMaster Carr will have them


On Tue, Mar 26, 2024, 12:42?PM W7WRX <clark@...> wrote:
Got one?? The bearings fell out of this one on the SR2000.??

C

 

Did all the moveable plates shift sideways, causing the gap in one direction to be much smaller than the other?? If yes, can you momentarily make the gap even by tugging (hard) on the shaft?? I had this problem in an antenna tuner.
Halden VE7UTS
 

¿ªÔÆÌåÓý

The ball bearings fell out.? That allowed all the plates to touch. Someone continued to operate it that way and burned up some plates.??

Even with new balls and adjustment of the end stop, all the plates are touching and kicked over.?
C

From: [email protected] <[email protected]> on behalf of HF via groups.io <incorridge@...>
Sent: Thursday, April 4, 2024 11:40 AM
To: [email protected] <[email protected]>
Subject: Re: [HallicraftersRadios] 3 gang Variable cap needed
?
Did all the moveable plates shift sideways, causing the gap in one direction to be much smaller than the other?? If yes, can you momentarily make the gap even by tugging (hard) on the shaft?? I had this problem in an antenna tuner.
Halden VE7UTS

1 - 7 of 7