开云体育

hello, can someone tell me if the x28c256 memory installed on hp8920b can be copied with the programmer to have a .bin or .hex file to store it in case of failure. and if so, what results did it give?

After opening the other 40pin Epson 32k card that was HP branded, all I found was blobs of epoxy.? No joy. I did order out some 512k ultra low-power chips to try in the Agilent card, but is on the

Just a little more detailed description than was posted here before. Hank ______________________________________ There's a problem with dbm levels *only* in spectrum analyzer mode.? The 8920B

Thanks Hank. I'm sure there are members here with a lot of knowledge to help me. thank you for your support. Regards

Your English is fine. Maybe the temperature dependence and the screenshot you provided will give someone some clues as to where the problem lies. Hank

Dear Peter, I tried to clean all modules and all coax cables, but I wasn't successful, when HP8920B is on for 1 or 2 hours the failure is constant, but after 3 or 4 hours on, this failure becomes

Hi Alemao, After some time the rigid co-axial cables at the underside of the unit develop poor connections due to corrosion. they are very small and delicate but with care can be disconnected and

Hi I have got an intermittent error with my HP8920B. The error is "Receiver assembly (low)". Could someone please provide some clarity on this issue. Thanks in advance!

Thank you, Alexander, for your email. Pls note that as I wrote in my previous, in the next step I will try with a sync separator. But I think that reporting this easy way to get a picture to the

08/08/2021 12:10, sv1mne wrote: Ok, if you think that it is working missing a piece of the screen, feel free to use that way. -- https://www.tabalabs.com.br https://tabajara-labs.blogspot.com

Hi Alexander, it definitely works without a sync separator, via the Y Composite input (at least on my GBS8200) The picture I get is exactly as yours in "A proposito, ninguem questionou "e se colocar o

It does not work, you gotta use a sync separator and inject composite video on g (or r or b) input of analog video and composite sync on sync input. Yiannis wrote:

Hi Alexandre and friends, The connection I made is as follows: 1. From HP8924c video out (BNC) to GBS8200 Y-video in (RCA) with BNC cable and BNC to RCA adapter 2. From GBS8200 VGA out to Samsung

Sorry, I wasn't able to understand. You got the GBS8200 but you're connecting the tv directly to the SM? It wont work, you gotta build the sync separator and connect it on the GBS8200 as I wrote on my

Thank you Friend

You may be able to shrink it in your Monitor's setup H-Size and H-Center

The following photos have been uploaded to the SV1MNE Photos ( /g/HP8924-Family-Spectrum-Analyzers/album?id=241724 ) album of the [email protected] group. *

Hi again, My GBS 8200 V4.0 has arrived and I managed to get a display on my Samsung TV monitor directly from the video RCA connector. The image is crisp and steady,? Black and White, which is nice

hello OLIVER_D can you tell me what options your instrument has where you have done the cal_dump? since you are much more experienced than me according to you or whoever reads it is possible to dump

Hi Robert, Yes. That is the program that I have been using to convert the DOS formatted files into LIF formatted files. That doesn’t seem to be the problem, though as I get the same result whether