开云体育

Yeah, that's a rare one apparently - have had it in my evilbay watch list for years now with no hits other than an occasional manual for it. -Pat

True my manual and equipment are 83592c, but that leaves still the YTM as a cause

Hi David, Avnet (AKA Farnell these days?) claim to be able to get the PIC17C42A-25I/L (44 pin, -40 +85, 25 MHz part) in 4 weeks with an MOQ of 1 at ~11 Euro but other than that - as I guess you found

So far, no cigar. Simply changing the string from 54712A to 54717A leads to an "Unknown" module detection. There's some checksum involved, I need to look close to that binary. I've uploaded the

Farnell are expecting some next month https://uk.farnell.com/microchip/pic17c42a-25i-l/8bit-cmos-mcu-smd-17c42-plcc44/dp/100924?st=PIC17C42A Robert G8RPI

Hi Dave I am in the UK but sorry I do not understand what you a after so haven't got one Paul B

Greetings, Thanks again to all who have replied helping my friend and myself to get this Agilent Infiniium scope operational. As was pointed out to me I had mixed up the digits in the model number.

A lot of us around here feel that way. :-) -Dave

Thanks Chuck. I will check that when the unit shows up. I've refurbished those HP 35 batteries in the past. Can do that if necessary. (probably is) In the 8350, is that a snap-in pack or individual

Extended temperature range PIC17C42A version in PLC44 ... Thanks David

Hi Chuck That reminds me I must order some new cells as all of my 8350 are running without any batteries Ok winter job I have collected a truck load of 8620 10 off so must service and make good should

I can't help marveling at the workmanship that went into that equipment.

Gentlemen, There is also a 3461A, which is the AC-Ohms converter for the 3460A. It’s the equivalent of the 2410, I believe. I’ve never seen a 3461 outside of a catalog. Jeremy wrote:

I have a 8903 and have used it with home-built audio amps. Many years ago did I build a dual (as in stereo) dummy load. It is just rated at 21W but that is usually sufficient. It has a bunch of

Hi! I've got an 83650 signal generator that's starting to get slightly anemic in power level right below 20GHz (8dBm -- it used to be 12 or 13dBm). I went through the YTM bias/tracking calibration and

Note that the 8350B has a 3- AA cell nicad battery, repurposed from the HP-35 calculators. The pack is on trickle charge whenever the 8350B is turned on, and after a year, or two of that abuse, spews

I would suspect the YTO. I have seen several fail over the years...... The YTO output at the rear side is a good starting point.....Good luck, 73? de Harke

There is no YTF in the A and B models : only in the C On Saturday, December 14, 2019, 3:42:47 PM GMT+1, <pa0jme1952@...> wrote: I took a look at the blockdiagram of my 83592, which differs only

I took a look at the blockdiagram of my 83592, which differs only with an extra low band mixer, The sweeper unit is a cascade of a) YTO o/p 2.4-7.0GHz b) amplifier c) isolator d) YTM (multiplier) e)

Re: [HP-Agilent-Keysight-equipment] HP 16500A Problems Hello All, Anyone know anything about the power supply made by the OECO Corporation 080-20521-01 that is used in the 16500A I seem to have cured