开云体育

Hi All, Looks like it's "request a service manual" time. The mil site had nothing. So, I request it. thanks.

Just bought an HP-184A scope today at the monthly Livermore Electronics Flea Market. Plus, a Tektronix 7704A mainframe scope....$ 15.00 !Checked it at home.The readout does work.In decent,good

Walter, I looked up your HP part number, 1884-0019, in my copy of the FedLog (Federal Logistics) database. This is one of the first times it hasn't shown ANY equivalent part numbers and other

Hi, does anybody have some spare TO-3 Hp 1884-0019 parts? they are SCRs or Triacs used in power supply pre-regulators, RCA was the manufacturer. I need either the real part number or some HP parts if

Just wanted to see if anyone might be interested?? Project Location: AZ Project Name: Test & Debug Engineer - Digital and Analog Desired Start Date: 02/02/2004 Length of Engagement: 6 Months Primary

Darrell, Free downloads: BAMA should have one also LOGSA Cheers Richard VK5ZLR

Any 8640B manuals lurking out there?? Darrell W4CX

hi guys i am trying to locate a hp part or compatable part out of a hp8558b it is a hp part number 5062-2805 or sugest a online cross reference guide i can check out Thank you , Ian Wells, Kerinvale

Well, looking at this here manual, there is a RUN/TEST switch (A1S1). The test switch is A1S2 ( 6 pin DIP sw) . You need to set the COAX/OPT switch (A1s5) TO coax... finally, you have to set the

If I Recall, The Maximum Cable Length For HP-1B Was 20 Meters. Perhaps Someone Else Knows For Sure. Greyhawk

I've recently tried to use a pair of old 37203A HP-IB Extenders to extend the distance of several IEEE-488 instruments from the controller. I don't have a manual on hand, but I thought the units

I'm looking for service & cal info or manuals for the following. HP 8640B Opt.323 (not commercial 8640B) AN/USM-323. AN/USM-338 oscilloscope. Any leads would be much apprieciated. Roger

Ian, In the HP 8558B service manual, it looks like those switches are just assemblies of many different HP part numbers. I could be wrong. I've never looked at an 8558B. But I didn't notice a part

Would anyone know where I can obtain the rotary switches on the front panel of a HP8558B plugin? thanks ian

Does anyone have any CPU Board data. I have the service manual such as it is. I'm having a problem with the analog bus voltages coming up as out of range when I measure them within

HI guys I have a HP 8558b with a hp182t m/f I have two problems one is the display on the 182t shows a sharp dip in the middle of the screen wether the 8558b is plugin or not . the second is the 8558b

From what I have heard (so cant confirm) is that when the progs are copied from the orig disks there is a bit set on the orig and the copy of the program that allows only one copy. If the orig

Lloyd I'll gladly contribute some dead A/D boards to the reverse engineering cause. This board is probably the single largest failure card in the 54111D family. People will buy up 54111D carcasses

I am interested in manufacturing replacement A/D boards for the HP 54111D. I saw comments on the unavailability of schematics. Does anyone have further info on contacting Agilent or reverse

<mike@a...> wrote: my They Probes leads are passive. You just need suitable 0.154" conector blo