开云体育

hp_agilent_equipment@... writes: Gentlemen: You might try an MTA-156 IDC receptacle used for wire-to-board interconnection. They are available for about $1.00 each. The 12 position

Yes. That's it. But... The HP1631D is a different (older) unit than I thought. So, my advice isn't as applicable. Looking at the pictures in the two auctions below, the probe tips

Hello Mike, you sells. most the you Do you mean this pdf? http://cp.literature.agilent.com/litweb/pdf/5968-4632E.pdf The logic analyzer has the PODs. and they contain - as far as I can see -

Keep an eye out on ebay. Every now and then, someone puts up a set of grabbers (just grabbers without the pods) and they tend to go for about $20 per set of 20 grabbers. Of (just in case I

My usual plea.......anybody have a list of 3586c commands? (I never get manuals with my stuff)... Thanks to all who replied regarding the peeling meters and all.. 73 Tom

I have a 1631D with all the Pods, but missing grabbers... And finding affordable kits has been impossible... Is it possible to make grabbers myself? I thought the Pods have MTA 156 connectors.. And

Hi All I have obtained some software for the 4952A protocol Analyser. These have been copied using the LIFUTIL utility. However wheras the data files work fine the applications (things like a VT100

I have a manual for 204C. If that would do, I can send you schematic; manual is too many pages to scan. Even better, the whole manual is on BAMA site ( http://bama.sbc.edu/hp.htm ); that site has

The original message was received at Tue, 2 Dec 2003 22:35:50 0800 ----- The following addresses had permanent fatal errors ----- <greg_werstiuk@...> ----- Transcript of session follows

Hello, Did You Try Bama. They Have A Few HP Manuals. http://bama.sbc.edu/ Greyhawk

Does anyone have an e-mailable manual (or at least a schematic) for an HP 204B Oscillator. It would be sincerely appreciated. Tom Leedy Clarksburg, MD

Hi Sam, I have the PDF manual for a 428B model if that will help. Regards, Jim --- sreaves22655 <sreaves@...> wrote: __________________________________ Do you Yahoo!? Free Pop-Up

Anyone have an emailable copy of the HP 428A? Sam W3OHM

Have you asked sphere? http://www.sphere.bc.ca/test/hp-parts/hpparts7.html he hasn't those knobs in his list yet, but to ask him is always wise Jorgen dj0ud

My 3580A spectrum analyzer works great but is much in need of a set of knobs. All the large ones with labeled "skirts" are either broken or missing entirely/replaced with nonlabeled knobs. Any leads

Greetings - After searching the excellent lists from tbfowler, came up dry. Looking for service lit/schematics (have the operating manual) for this HP54720D scope 4G amp plug-in designated HP54721.

Hi Scott, That would be great. Thank you so much Mitch wrote: happy to scan HP

Hello all, I'm looking for an Hewlett Packard component, for my HP3336B generator. It is marked as "1SB1 0021". Could you please help me to find this component? Thanks for your courtesy Best

Hi Mitch, I have a 451B service manual somewhere. When I find it I'll be happy to scan the schematics and send them to you. Scott _____ I've stopped 3,696 spam messages. You can too! One

Good Morning Gentlemen, I have sent in a few new HP scans to BAMA. Good on ya BAMA! -Richard VK5ZLR