开云体育

Hello All, I'm welding up a 19" Rack assembly to span an 8' bench so I can mount the gear up off the table and I'm looking for the screw on rack ears, the plastic spacers used to mount a couple of

It's really very simple. The center conductor of the connector goes through a 53 ohm resistor to one side of the pickup coil, the other side of the pickup coil goes to the sleeve. The center

Ross, I have a Tek 2465BDM sitting on top of the non vent part of the 54111D. As much as I would love to, it sounds like I shouldn't put a 3456A under all of that. The vents on top of the 54111D stop

Hi, I have 2 HP3456A and I really like them. The HP3456A is a shallow chassis. The HP54111 is about 4 inches longer (part of that is the rear feet). I have stacked alot of weight ontop of mine

Wow, thanks for all the info. This will help me make up my mind as to the direction I go. The boss lady has said no purchases until after x-mas. So I'm doing my research while I wait. Think I can put

All issues, 1 through 37, of "The Notebook" are archived here: http://www.hparchive.com/Boonton.htm 73 Glenn WB4UIV

Ok, the 5335A is now working. One of the group members kindly came up with the needed cables and that led me to the original problem with the unit. A bad input fet, 1855-0300, Q5. The best I could

Hi All I think I can help answer this: At a hamfest last year, I picked up a complete collection of the Boonton Radio Corp publication " The Notebook". This was a periodic publication by Boonton

Yes, I know, thank you. In fac, there are yellow stickers warning about it on the covers. I went ahead anyway, I'd rather have them a bit off than the others unusable at all. No free lunch, I

Thanks Ed, I will take a look at those control signals and see what we find. Roberto EB4EQA

Hello all, I have an HP 8551 spectrum analyzer I would like to offer for sale or trade. It works reasonably well, as I describe in more detail below, but I am starting to upgrade my home shop with

Where can you buy one of these for $50? Bob

The 3456a was the most accurate in the HP fleet when introduced in 1981. The model line was 345x, so in its heritage was the 3455, 3457, and finally the ersatz standard DMM today, introduced in

If you open the castings of the 70902A, the filter shape of the 3 or 4?narrowest ist lost. Aligning the filters can only be done by the dedicated software. ________________________________ To:

http://aubreyloganterry.com/images/qj35990x.php

Agreed, winter here, humidity < 20% and insane static levels. A 3456A can read multiple volts on open terminals around here. Short the terminals with a short section of small (say 28ga)

Missed this. Pretty heavy but not 100 lbs. I used to work on 620, 616, 614 generators and could manhandle them without too much trouble. These and the 608, 612, etc, were built like steam

On 12/22/2012 12:09 AM, Merchison Burke wrote: > > If I recall correctly, I believe that the sliding portion of the > attenuator can be removed from the fixed portion to effect repairs on > the

Are you aware the very cheap DMMs are often only 1 Meg input resistance instead of the 10 meg in better meters. They can still be very useful as long as you realize they can load a high impedance