开云体育

UNOFFICIAL I have never encountered 3.5 mm in anything, and yes I have seen them on Amazon and AliExpress, but never at hardware shops, electronics parts suppliers ( similar to radio shack) or even

In my own shop, I am, kicking and screaming, "inching" towards the metric system.? I have a rather complete and well-organized set of little drawers for my SAE hardware, but the metric stuff

Hi, bought a E5071C 4-port 8.5GHz VNA. Seller stated that the device does not power up. Arriving home I connected it to power switched it on - it turns on, Fans blowing for 3-4 seconds, no other

HP series 200/300 and Plotter Manuals PM direct for offer… 7470A Plotter, Statistics, Graphic Presentation, Project Management, Basic 4.0… Interface Techniques, Utilities, Waveform Analysis,

The following items have been added to the Files area of the HP-Agilent-Keysight-equipment@groups.io group. * /All HP, Agilent and Keysight instruments in folders by part numbers/3000 to 3999/33xx

I also designed a 10 MHz LC resonator version with the aim to run the resonator at fairly high power. I've a fair bit of experience designing discrete low noise gain blocks so I replaced the noisy

Alberto, So, do you know if the CLIP document you have is useful for the E4422B or at least for the E4400-90141 module? If so, could you contact this email *santi.zygadlo@...* to reach an

I did of course Andrew, you are right. I was not well awake decidedly this morning!

(32 threads / inch) * (1 in / 25.4mm) = 1.2598 threads / mm 1/1.2598 = 0.79375 mm / thread (pitch) That's not even CLOSE to 0.6mm pitch (42 / 25.4) = 1.65354 threads / mm 1/1.65354 = 0.6048 pitch I

Sorry I got myself confused between the two systems! It's of course 5 micrometers so one large hair thickness! I kick myself...

Indeed in metric land 3.5x0.6 exists. If one calculates the diameter and pitch in mm of your 6-32 one gets: 3.505x0.605 which is just one micrometer too much or one fifth of your hair thickness... In

Radu Bogdan Dicher <vondicher@...> added the photo album Microscope ( /g/HP-Agilent-Keysight-equipment/album?id=301362 )

To assist with feedback on this local offer for the Nikon microscopes, I uploaded to the photos section pictures of the two units this local seller has:

What a beast. I’ll have to find one as a project. Peter

I will, IF.

And that, my dear sir, is exactly why I wrote the program. Please contact me off? list.? I didn't exactly design some of this for public consumption (mostly the Embarcadaro stuff), and you'll need

I'm on (the other) HP 8673D repair project now. This one never worked in the time I have owned it, and I'd been storing it as a parts mule, but decided (now that I have some experience with

Hi John, I uploaded the "Installation and Getting Started Guide" to the files area. I don't have the software. I was looking for it a few years ago but without any luck. I think it was delivered on a

M3.5 is a standard size 3.5x0.6? the odd one is 3.5x0.5 and yes it exists I have a die for it and the 0.6 ( i use the 0.5 in music instrument repair-silly saxophones).....0.7 never existed nor should

Don't grab it, just try it some and see how wide the eyepiece viewing angle is... When it's narrow you get neck strain quickly keeping your eyes just perfectly located.