开云体育

John, if you’ll share your email address with me, I’ll send the schematic. Jeremy N6WFO [email protected]> wrote:

Good point. I’d rather patronize Artek and save us both time and money. Jeremy N6WFO [email protected]> wrote:

David, The Artek manual for 466a is actually 00466-90003.? There's a typo on the website, I'll let Linda know. It's for serial prefix 226 with backdating for 210, 044, and 019 prefixes. Ron

Dave, The Artek manual for the HP 466A is for serial number prefix 226. Ron

Hi, I just pulled my 3708A off the shelf for a bit of a spit polish ready to sell it off and I'm looking for a service manual for the performance test and calibration procedures. I can't seem to

Hi, Starting point VCXO are correct frequency with 40.000MHz. At TP20 you have a frequency of 39.100MHz, and at the output of divider 40 you get 977.5kHz. This indicates, that the divider by 40

wrote: A very useful amount of cleanup can be done simply by comparing each pixel on its own to the average of the wide neighbourhood pixels. That works equally well for text and schematics, since it

At the museum, we use ITU-T T.6 (Group 4 FAX), which is lossless and very effective. -Dave -- Dave McGuire, AK4HZ New Kensington, PA

I don't mind getting it scanned at the museum, but does it still make sense to do that after the revelation that Artek has it available? I hadn't checked before; I had assumed the OP had already

I've got one of those amps and would like the schematic also. -- John Griessen

While we seem to all agree that JPEG compression is not ideal, there ARE lossless options for TIFF and thus PDF formats.? While yes, storage and networking and processing and scanning time is all

Yes, that's why I wanted to see a picture. I've never seen the ball-of-molten-tantalum failure on anything other than a dipped unit. Seconded. -Dave -- Dave McGuire, AK4HZ New

The manual on the web gives type 150D for C1 & C2 on A7, these are hermetic sealed solid tants, of course they might have been replaced with a bead or the disguised bead in an axial or radial block

I don't know if this helps, but I dug out the most recent Keysight calibration certificate for this E5052A and there is a noise floor test done at 70 MHz with correlation set to 1. I'm not sure what

For reference list of the component I have on the A12 board: - 10H116 : Triple line

This is a long shot (and I know nothings about this particular piece of equiptment), but here goes: I have an Agilent N5030A which was not booting.? I changed the battery on the mother board (and

-120dBc/Hz at 1 Hz is way better than anything I've experienced. I had a look at a plot of my homebrew oscillator and it managed -116dBc/Hz at 10 Hz.? Pretty lame by comparison... I guess you are

On TP20 I have a RF signal is at 39.280 MHz, -1.3 dBm ?for frequency <16 MHz instead of 39,996 MHz ?--> Delta is 716 KHz On TP14 for a 10MHz setting on the VNA I have a 2sd LO frequency at 10.720

Hi Leo This E5052A is quite old now and it does have a few internal spurious terms. Also the noise floor performance isn't that great even down at 10 MHz. I don't have any oscillators here that can

Hello Yves, Thank you for your last post. My VCO frequencies in TP20 *are not correct*. I have : - a RF signal is at 39.100 MHz, -1.3 dBm instead of 39.840 on your board for frequency >16 MHz - a RF