开云体育

Synthesizer lock on all frequencies but has about a 10 KHz FM signal on most frequencies. Using a scope on the output pins of the Phase detector chip shows the expected pulses but about a ten KHz

Can anyone point me to a pdf or something on line with HPIB command list for the 8753? r Tom WB3AKD

Does anyone have an operator's manual (or O/S manual) for the HP 6177C current source that they can lend me?

I sorry to get off topic but I have tried many forums looking for a schematic for a Eurotherm 832 power supply. Eurotherm list this with a 831 on their web site, but the 832 is different.Eurotherm

Thanks to all for the replies. The second one http://groups.yahoo.com/group/TekScopArc under files had a copy of the schematic I needed. Both sites have information under

Thank you, Jorgen. Regards Miroslav Pokorni

Dear Colleagues, I'm looking for a HP 5355A plug in (frequency converter) for use in an HP 5345A counter. Anyone who has a spare kindly email me at: cesium_mike@... Regards, Mike,

<mpokorni2000@y...> wrote: http://groups.yahoo.com/group/TekScopArc/ Jorgen dj0ud

Hello Doug, What is the second Tek group. Regards Miroslav Pokorni

thanks Fred I did find 2 groups of interest for Tek on Yahurl. Doug <fwolsen@e...> wrote: TekScopes@...

I have a 5300A measuring system readout with a 5302A 50 Mhz counter. When I first turn the unit on, with the function knob dialed to "check" the counter reads 10.0000 Mhz but after it warms up for a

No, but there's a Tektronix group here on Yahurl. TekScopes@... Fred -- <>< -- Outgoing checked by Norton AV

Anyone know of any Tektronics forums? thanks Doug

yes is a 12 pin Jones connector. Yes I would be interested in that information.Either reply here or send me a e-mail dmac1054@.... <tractorb@i...> wrote: pot- I

If its a 12 pin jones connector its probably for a retransmitting pot- I can give you that info if you still need it. Dave Brown Christchurch, NZ

Hello Tom, I have a Motorola's MC12040P, what is plastic DIP, as oposed to L part, a ceramic package. I can mail you one piece if that would do it for you. Regards Miroslav Pokorni

Folks, Looking for the following ECL chip HP P/N 1820-1344 which crosses to Mot MC12040L Phase detector. Thanks Tom

dmac1054@... writes: Thank you, Doug. I will! Regards, Don

Hello Don, The old age does not lend itself to quick thinking. I just sent you an e mail offering to send you few panel nuts and did not think that you were talking about "speed nuts", but then you

Those guys might have a minimum order. I just remembered that I have few from a DEC's rack. They are square piece of metal, about 3/16 " thick with 10-32 thread cut and a spring retainer. If just few