开云体育

Thanks, Gabor. That makes sense and I don't think it'd be so bad even in the long term. I'd personally do it in a way where this can be serviced again (in 10 years or... 25!), and a socket would

Thank you, Steve. One other unfortunate effect of the spot-welding of the top tab is that the battery code is not visible. I can probably destroy the battery once out, and read the CRxyzt battery

I'm a bit ashamed to admit that in such a case, I'd probably hot glue a battery holder that I already have in place of the original and connect its leads with a pair of short wires to the pads. If

When you get to the bottom side of the PCB, I'm pretty sure you'll find three "leads" sticking thru. Two go to the top side of the cell, and one to the underside. You'll need to carefully desolder all

Awesome. Thank you guys! I only did just about enough prying to figure this mustn't be the right way to remove, then asked here. It sounds like it's not a ten minute deal and needs weekend time to

Stop prying! I've used that type battery many times. The tab on top is spot-welded to the cell, with two fingers soldered thru the PCB. underneath is another, smaller tab, with a single finger

Just my 2 cents worth, I think that battery is soldered in and the tags/clips are spot welded on to it. You’ll probably need to remove the board assembly to successfully remove it. I think any more

The triangular tab is spot welded to the coin cell and then the legs of the tab are in turn soldered to the board next to the resistor. A great way to force the repair technician to completely

Peter, Thank you! DaveD KC0WJN [email protected]> wrote:

One can see a lot of scratches on top of that - I think someone before me tried replacing this with limited success. <vondicher@...> wrote:

I lifted today the CRT card, just enough to have some access to the battery, but I'm still unsure how it's supposed to come off. I tried prying the top spring "leaf," but it seems attached (possibly

There are several 3D models on thingverse. ?Just search for HP Agilent 8753. -- Tim Wright Senior Engineer Cumulus Media Chicago - WLS-AM AL7DS

As far as I can tell all of the TWAIN files are being installed correctly, the scanner appears in the Windows hardware list but does not appear when you interrogate TWAIN devices I do not have a good

As long as there is a "twain" windows driver for the beast you might try NAPS2. Dave

Following the unlocking of gray scale mode on the Canon MS-800, I have scanned the service manual for the 11707A test plugin. I have uploaded .tiff files for each page to the temporary file section

Hi Michael, I will DM (if that is possible) you about this. I too have a Minolta MS-6000 Mkii (aka Kodak 24000DSV-E) that Windows can see but the supplied scanning software steadfastly refuses to

I have uploaded a compressed .pdf version of the 11707A service manual to the files section.? Apologies for the watermark - I will add a watermark-less version to the by instrument area of the files

You could always do an OLED conversion.. https://www.eevblog.com/forum/testgear/hp3548-hp3457-oled-display/ I have made a few and they look fantastic. Won't help with the LCR meter, but should be

Hi, I have a HP 8752A VNA without the bezel for keys left side of display (ser photo). Does anyone know where I can get one or photos/measurements so I can design something and to 3D printer,

I suggest taking a look at the HP3488 Switch Unit LCD modules, which are very similar form & fit. I successfully added some LED lighting as an smd strip (side edge on) inside the moulded frame. It