开云体育

Good point, even though my main AP S1 has FFT, I prefer outputting the signal through the monitor outputs and using my Lynx L22 to do FFT. It's far faster than the AP's own (which precedes it by a few

Hello Matej, I have soldered many components (power transistors, dummy loads, smd parts) with bismuth containing solder paste on a hot plate. I have a cheap household hot plate and use a simple

Hi, I couldn't find a suitable answer, so I'm reaching out here. I have a Diconex 1.6kW flange resistor, and I'm considering direct soldering it onto a copper plate with water cooling. I'm unsure if

Keeping in mind that this is coming from someone that just puts on a dust cap and calls it good... A hard case with the perforated/pick apart foam sheets, sold about everywhere.? Usually marketed as

I finally just bit the bullet and picked up a used (with warranty!) Agilent N8482A power sensor to add to my 8481A sensor that I use with my E4418B Power Meter. I'm wondering what people use to keep

I doubt this is a practical issue for 410C use unless you were dragging that thing around in a rugged use environment. For two reasons.? IIRC, the DC probe has a 1M resistor in the probe tip so

Solved by peaking how KE5FX is doing this: read error messages with "OUTPERRO" prior to reading the plot. Tom

Hi folks, I am reading a HPGL screenshot from my 8510C with the command OUTPPLOT. So far so good. But when transmission is over, the 8510C screen shows the message "PLOT COMPLETE". Now, when I grab

Ok looking into this the VNA will not directly provide Q information but can easily provide SRF.? There is some calculations that need to be done to obtain the Q.

OK? I do have a VNA - didnt think to use it as a inductor tester.

Small RF inductors? 2.2mH and 2.7mH

RG59 or RG58 ! Am 25.01.2024 um 10:33 schrieb Steve Byan:

The 410C DC ranges go up to 1500 volts. Unfortunately the Mogami W2546 cable is only rated for 500 volts DC: https://mogamicable.com/category/bulk/video/subminiature_miniature/

Hi, Here is a link from eevblog, also search for previous messages using "Binder 719". This AUX probe connector topic has been discussed several times. It is used also on other spectrum analyzers

Hi This power plug have been asked for a lot of times--the Lemos doesn’t fit.The closest we did find were a plug from Binder. Will look it up tomorrow-not home. Hardy -----Oprindelig

Matt et all Yes the newer FFT based instruments are far superior to the old. Try look at https://e1dashz.wixsite.com/index/cosmos-adc Its build primary to test AD converters,but it can use readily

Oops! Dave is correct after all. I didn't realize that Lemo makes smaller connectors, but they do. A colleague thinks that it may be part # FGG.1B.303.CLAZ, available from DigiKey, for

I haven't seen Lemo knockoffs in my previous searches, but I also haven't looked in some time, so thanks, John, for mentioning that I should give it another go. --Cheers Tom -- Prof. Thomas H.

One of those tiny cheap $50 VNA would do the job as well.? And if a guy does very much RF work at all, a VNA is a **exceptionally** handy gadget to have laying

But some knockoffs on aliexpress work OK...for far less...