开云体育

Hi all please disregard the message? as we have it on the hp 70000 site It got missed as the part number does not have the model number in it

Hi all a member has informed me about HP 5960-7083 70340A/70341A Signal Generators Calibration Guide being available on Ebay HP 5960-7083 70340A/70341A Signal Generators Calibration Guide | eBay (

Hi Vladan… Pin 14 reads about 4.5 Ohms to ground. I have another Source module for comparison that reads a bout 1.5K. Now working on how to determine shorted part. Have eliminated the attenuator,

Got it. Thanks. Will report back when I see what’s what in that area. Sent: Wednesday, November 24, 2021 9:56 PM To: [email protected] Subject: Re:

I am looking at a source module as I write. I am not sure if 22V goes anywhere else in the instrument, but on the source it connects to pin 14 of P1 (that long brown AMP connector that attaches to the

Thanks Richard and agreed... off to theta land

Hi Jerry – I have some 8640B “hangar queens” in the basement. I can probably help you with another internal oscillator. 73 – and Happy Thanksgiving – Mike Mike B. Feher, N4FS 89 Arnold Blvd.

Yes, the +22. On the post-regulator board the light labeled +22 is out, even when the rest of the LEDs are flashing. When I remove the source module, all is well with the LEDs. Removing the other

Can you tell which power supply is being overloaded? Vladan

Other than one that Vladan posted a few years back of the YIG circuit pinout, has anyone ever found or created a schematic or even just the pinout for one of those modules? The one I have just started

soda -> keyboard -- Dave McGuire, AK4HZ New Kensington, PA

Yup. I don't know how harmonically impure that 40kHz sine wave is, but there probably wasn't much motivation to make it perfect. Heat is the big issue.

Thanks Paul, I dropped Dave a line… Sent: Wednesday, November 24, 2021 11:10 AM To: [email protected] Subject: Re: [HP-Agilent-Keysight-equipment] 70900A Artek CLIP Manual Hi

I'll give you a rough idea when you fix the thing! Vladan / Vladen / Bladen

Couldn't agree more DF tan theta are more useful for me. In this case, readings I got on the 70900A caps, theta speaks loudly of the dielectric absorption with increased frequency and plummeting

Damn....VLADEN...I'll get it right yet... Sent from my T-Mobile 5G Device Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Wednesday, November 24, 2021 3:56:59 PM

Darn spell check sorry VLADAN Sent from my T-Mobile 5G Device Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Wednesday, November 24, 2021 3:25:46 PM To:

You know, I keep telling people that, and people keep telling me I'm crazy. All converting DF to ESR does is introduce a frequency dependency that gets in the way of deciding "good capacitor" or "bad

It may prove more useful to use dissipation factor rather than ESR even though both are a measure of the same thing. Since DF is a ratio of reactance to resistance it varies with frequency and may be

Bladen I gotta know...where did it live? Sent from my T-Mobile 5G Device Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Wednesday, November 24, 2021 11:10:08 AM