开云体育

I have the following manuals available for the cost of shipping from 45409. Most are originals though a couple are good quality copies, and most are in HP binders. 1. 3585B Operating, Service Vol. 1,

I will study your writeup with great pleasure once you have it organized and published. Remind me how you are matching your H11F's and canceling the remaining offset. Dave Wise

I would like to buy these! Please contact me directly at fourdesigns@...

Sorry for the bandpass. No reply from you On Tuesday, March 3, 2020, 01:59:48 AM GMT+1, Bob Koller via Groups.Io <testtech@...> wrote: JF, Thanks, I have contacted you, (I think),

Hi, This is pretty similar to what the 8640B signal generator does. You can lock the oscillator to the quartz time base via the counter. Then by changing the counter timebase you can fine tune the

At 2020-03-02 03:51 PM, Mark Litwack wrote: Page 3 of the *CONFIG* menu for the sync settings, not the CAL menu. Thank you! I would never have figured that one out on my own. Now I can actually see

Hi Steve, Thanks for the confirmation! I also had good hopes it would work. Now all I need is an image to load ;-) But that requires someone that can get LIF files off of a disk. My machine does have

Thanks for the tips Vladan, did not consider that type of impact from vibration. I definitely will check out the vibration when I move out the machine to get to the rear ports. I also hate the weight

Check the rectifier feeding C5. The capacitor will get hot if there is AC on it from a shorted or leaky diode. Robert G8RPI.

If you haven't seen yet Mr. Carlon's Lab just did a teardown and restore with custom LED's and driver:?https://www.youtube.com/watch?v=vrmwql2msbU&t=639s

On Mon, 27 Jan 2020, Dave Wise wrote: OK, I've put everything together finally for the first run as a whole and it worked like a charm. Not fully assembled yet (covers not installed) but otherwise

Got a new 3.5 Female cal kit today and a thumb drive with the data. ?It’s non HP but the cal data seems not bad ? Not that I really know much. But did get a chart of numbers Moved the .CK and XKT

JF, Thanks, I have contacted you, (I think), through your contact in on this forum.

Sorry for the delay on the response. It does not have option 004. I tried what Don B had said about leaving it plugged in. I usually don't. I do have a GPS 10Mhz standard that I leave on 24/7. Even

So, mouser has a set of 10 for $3 each: https://www.mouser.com/ProductDetail/Pomona-Electronics/5520?qs=mF%2FuAlTFnPpb%252BmlVceiP1Q%3D%3D and the ones I referenced earlier are under $0.70 per unit,

Similar clips are Pomona 5301-6, or 5419-8-0 (ignoring the wire).

Sorry, I cannot find your direct address ( testtech@... ???) : I have for sale the two extender cables, p/n 11672-60001 and 11672-60002 for the 8660x signal generator series (with the

There were some RF connectors that looked like the RCA phone connectors, except that the center pins were shorter, used in General Electric mobile radios, up to 460 MHz. I would assume that there were

I'm looking for a CRT to restore an HP Storage 1331A XY. The original part # was 5083-2578 but I don't know what compatibility with other tubes is like. If anyone has a copy of the 1331A operator's /

That must be a recent thing; I got an upgrade for my C to an E about two years ago. (for actual cellular development work) Maybe. But why not just get a real spectrum analyzer and signal generator?