开云体育

but I really think they are bot the same copy. I mean can that user have begun to sell the Milan version on eBay? [email protected]> ha scritto: -- *Alberto Vaudagna*

No, not me.... [email protected]> wrote:

Does anybody have a 3D model of Agilent 5041-8820 Rear Strap Handle Cap? Mine has shattered and I'd like to replace it. I have the metal insert so only need plastic outside piece. Cheers Leo

Hi Milan, I have bought mine in 2018 from a random eBay dude with account called "Jimt4". Was that you? If not, I assume am free to pass them on. Leo

I took a look in my fiche documentation - I do not have anything for the 4934A. If you look here in the first pdf (ending 01) - [email protected] | Files (

I see your point! I was in possession for like 10 years of the original schematics from CAD (so no scan and bad quality this time) of the tektronix TDS540 scope that I received directly from tektronix

Hello everyone, Everyone who purchased the clip E4400-90336 from me (CLIP content attached) was kindly asked to use it for their own private use and not distribute it...which is why I archived it to

Hi Sven, you have to place a new CR2032 on the mainboard, then do a CMOS default and set the correct date/time. Normally, after that all should be OK. I had the same issue on mine, fixed it that

Hey Yves, Thanks for your answer, but this was the source i mentioned. I found it before, and it works, but you can See a lot of question marks in the structure. I try to find a description of all

auto zero function explained on page 15 of the 8481A service manual.

Have pdf of op/service for the 4935A if that’s any use. Dave, ZL3FJ Sent: Thursday, March 20, 2025 11:55 To: [email protected] Subject: [HP-Agilent-Keysight-equipment]

Hello, Any one have a service manual for a HP 4934A? An electronic copy? Any good ideas where to find either a paper or electronic copy? It is for a TIMS. Transmission impairment measuring set. thank

Unless you plan to operate on 400 Hz AC current, you don’t need a 400 Hz fan. Depending on the instrument, you may be able to get by with a lower-power (quieter fan). HP typically spec’d their

Peter - yes - beast (trivia - back in about 1981 I was one of hundreds of volunteer extras (person-sized bird characters) for a movie being filmed north of Los Angeles called "the beastmaster" - never

Have a failing/failed cooling fan from a HP machine with OPT 003 (400 Hz), which appears to apply to the type of fan installed. Are there any requirements (trying remember undergraduate EE class that

UNOFFICIAL I have never encountered 3.5 mm in anything, and yes I have seen them on Amazon and AliExpress, but never at hardware shops, electronics parts suppliers ( similar to radio shack) or even

In my own shop, I am, kicking and screaming, "inching" towards the metric system.? I have a rather complete and well-organized set of little drawers for my SAE hardware, but the metric stuff

Hi, bought a E5071C 4-port 8.5GHz VNA. Seller stated that the device does not power up. Arriving home I connected it to power switched it on - it turns on, Fans blowing for 3-4 seconds, no other

HP series 200/300 and Plotter Manuals PM direct for offer… 7470A Plotter, Statistics, Graphic Presentation, Project Management, Basic 4.0… Interface Techniques, Utilities, Waveform Analysis,

The following items have been added to the Files area of the [email protected] group. * /All HP, Agilent and Keysight instruments in folders by part numbers/3000 to 3999/33xx