开云体育

It is likely that they are imperial 6-32 pan head pozi-drive ( looks like a Phillips head, but slightly different.) The outside dia. of a 6-32 screw is about 0.138 inch (~3.5mm) and 32 threads per

With all the amazing improvements to the optics and imaging electronics over the years, I don't think you'll have much trouble there, except for assessing and deciding. Even in low-light conditions

My 8643 failure message indicated 5V supply failure. Voltage at test point measured 4.9 volts. I replaced all the capacitors in both switching supplies of the 8643A. Both supplies checked out OK

Nice. I hope mine works as well when I eventually get back to it.? Ed

Hi can someone tell me what thread the screws are that hold the back panel on? HP8656. I am assuming they are 5/32 as 3mm and 4mm metric are either too small or too big. or wrong thread Are the UNF ,

Having done enough (red) eye cracking smd soldering jobs or inspections in case of suspected failure (cold joints, etc.), I've decided to invest a bit on a better optical setup. There's plenty of

Thanks for posting a follow-up. Glad your 8643A is working. Tony AD0VC ________________________________ Sent: Sunday, March 16, 2025 6:26 PM To: [email protected]

My 8643 failure message indicated 5V supply failure. Voltage at test point measured 4.9 volts. I replaced all the capacitors in both switching supplies of the 8643A. Both supplies checked out OK

thanks Chris for the superb job ! adri ----- Messaggio originale ----- Da: Chris Weir via groups.io <chris.a.weir@...> Rispondi a:

Hi Tom, There is some information about this format here: https://github.com/jeremyherbert/barbutils Yves De :

Hi Marcus, Thank you for your idea! I followed your idea of sending commands to 8510c let it generate a binary file. I ended up writing a very small and primitive XML parser that's good enough to

I am using an old Toshiba Portege 7200 laptop which has the slim floppy drive in the docking station and it runs WinXP. This laptop has a P3 CPU/128MB RAM/64GB PATA IDE SSD. Never had issues with it

I contacted them, reply was that a search of email folders didn't show this sender. Use this email address, from their website. *manuals@... ( manuals@... )* regards,

Your PC must support 256 and 512 byte sectors and the number of sectors per track used by LIF formats to successfully read/write disks. “Super IO” chips that implement PS2 keyboard/mouse, IDE, a

Tried the Github version v2.0.0 as suggested. It could not read any of the disks Tried Keysights LIFUtils. It could not even format a 3" floppy to LIF using XP or W10. (Both O/S could read and format

Hello Community, I got a 33522a Arb Signal Generator. I'm still looking for a file format description of the binary arb file format ( *.barb ). I found some information about this format and I still

I uploaded a backup of the help webpage as well as the "full" installer with dependencies. ?When I installed this last November, I had trouble with the light version but the full worked. ?It is

The following items have been added to the Files area of the [email protected] group. * /All HP, Agilent and Keysight instruments in folders by part numbers/4000 to 4999/4192A

[email protected]> wrote: Could you please upload a copy to this directory which I created for the purpose. Place any information you found - a copy of the webpage would

[email protected]> wrote: Could you please upload a copy to this directory which I created for the purpose. Place any information you found - a copy of the webpage would