开云体育

Where does one got looking for new feet for the back of a 8672A? I just unwrapped my recent eBay purchase and its missing 2 of them. Unit seem to work and other than a broken off slide switch lever on

It is suggested that nobody posts on this forum - in particular do not start any new topics. Please go to /g/HP-Agilent-Keysight-equipment Somewhere between 21:00 GMT on Sunday,

although i've not tried it myself, there are many videos and posts showing that superglue plus baking soda makes a very durable material. 73 ac2pl

Hello, if someone has the system6000.jzp prior to 06.20.0000 Apr 23 2015 10:42:11 please PM me or post where it can be downloaded. On the Keysight site all the previous versions are gone. ?Many

Some years ago I bought a CertiPrime N9923A from Agilent. It developed a hardware fault within a month or so. Sometime later, someone I know bought an N9912A combination analyzer. I checked that for

If you have a drill press, you can chuck a threaded screw and drill the tap hole for 4-40 by feeding the quill onto a drill bit held stationary in a chuck. I used this technique to salvage an $85 air

Re: [HP-Agilent-Keysight-equipment] intro on groups.io Hello Pete, I'm sure people will move up here slowly, at least I only got your post once............ Sunday, August 19, 2018, 11:20:25 AM, you

Hopefully that will change now. I've put a notice on the Yahoo group, asking people not to post there, and instead use here. The number of members is increasing rapidly now. 8 People have joined in

I inadvertently sent the previous message before finish compiling it. What happens next 1) Please stop posting here. If you require immediate support, join

Just fixed some stripped bakelite knobs from a 1920's radio using 4BA Helicoils - worked great!

As most of you will be aware, the Yahoo group has been unreliable, and a decision has been made to migrate the group over to groups.io /g/HP-Agilent-Keysight-equipment I started the

How about these? Thread one onto the end of a long 4-40 screw, heat it and push it into a pre-drilled hole? Once the plastic cools, it shouldn't be able to move. https://www.ebay.com/itm/292170258299

I would think those better than any potting compound by far. Peter

What about Helicoils.?Leon Robinson ?? K5JLR Political Correctness is a Political Disease. To: hp_agilent_equipment@... Sent: Saturday, August 18, 2018 5:02 PM Subject:

See off-list mail. -Dave [hp_agilent_equipment] wrote:

JB weld will flow if you heat it. Regards

Greetings, I'm trying to save a couple old plastic knobs that have stripped set screw threads, that don't have brass inserts. I remember reading someplace about a machinable potting material that is

Hello, just responded offlist. Tam With best regards Tam Hanna --- Enjoy electronics? Join 8300 other followers by visiting the Crazy Electronics Lab at https://www.instagram.com/tam.hanna/

You can also get an add-on called

FWIW its??? dead simple. Thunderbird (52.9.1) = ???Tools - Options - General(tab) - Config Editor button on 3rd pane down (Advanced Configuration) then type/scroll to what you want. Typing 'dup'