开云体育

The Boonton cables start to have high resistance in the shields, allowing signal ingress ion. The Boonton 91 is a tube model (The only schematic I have is for the 91CA). It has a 50K balance pot

I have wanted an rf millivoltmeter for some time.? I was using my HP410B which is fine except it won't measure down to the millivolts. Then I realized that my HP54542A oscilloscope has great

Sorry, I was thinking about the B, not the C. Dave Sent: Thursday, October 12, 2017 10:57 AM To: hp_agilent_equipment@... Subject: RE: [hp_agilent_equipment] RF Voltmeter? Dave, Not

Dave, Not quite, the 410C has 15mV scale, same probe diode as 410B. Henry ---In hp_agilent_equipment@..., <david_wise@...> wrote : Apples and Oranges. The Boonton 92 is a

Apples and Oranges. The Boonton 92 is a specialized RF Millivoltmeter. The HP 410 is a general-purpose VTVM whose AC probe works at UHF. “Not quite as sensitive” – yeah, by three orders of

Michael, I think you are right. From the spec, the Boonton 92 seems has better sensitivity than HP410C, I don't have neither Boonton 92 nor HP410C so I can't comment on which one is actually

The Boonton 93 is a True RMS Voltmeter, usable to 20 MHz. Maybe he meant the model 92?

Is Boonton 93 more like HP3400, HP3403?

Great. Thank you! --------------------------------------------

Ok, I re-read your original post. Thank you for your patience. I used the calibrator sockets on the left side of the screen with 1 piece of wire in the negative and 1 piece of wire in the 10v socket

--------------------------------------------

Ok. If I can find any of my 32MB ones, I will try it and let you (and the list) know if it will recognize additional memory. -Dave [hp_agilent_equipment] wrote:

Unfortunately, I don't have a simm 72 pins more than 16Meg.

SMD parts are too small to have a human readable full part number, so manufacturers either leave them blank (thanks alot!) or put a code on them that uniquely ID's the part within the manufacturer.

For those of us on UNIX systems (including Linux), a quick and easy way to remotely activate an X11 session from a workstation is: echo "SYST:COMM:LAN:XWIN:STAT ON" | nc vsa 23 > /dev/null On

As you probably know already, the 5300A manual is readily available online but the 5303A does not appear to be. However, in November 2015 someone on EEVblog said that Dave of Artek Manuals had made a

The Leo Bodnar pulser output level is adjustable but at outputs higher than some 1 v P-P the rise/fall times increase. I reported the ~0.95 v P-P as what was reported on the datasheet for *my*

Hi Andrew You seam to be going in circles as you say I don't have a signal generator I posted text below on Sunday 8 oct Basically you do have a signal generator on the scope it is called

[hp_agilent_equipment] wrote: This is great news! I think it's safe to conclude that it works; it would likely have failed very early during the memory tests if there were a basic incompatibility

Send me via private email your original config file with AY9 enabled and I'll try to figure it out. A new checksum needs to be calculated to include this option, in the master config file, plus a few