开云体育

Try here: www.hparchive.com/*Manuals*/*HP*-*410C*-*Manual*.pdf Steve vk5abc wrote:

I know what the technical definition of a shunt is. However this is an HP inline device that they call a "tracking generator shunt (50 ohm output)" It is used and came with the 8556A low frequency RF

Hi Dan, You might try donating it to a local tech school or amateur radio club. All of the folks I know that are into test equipment have long ago traded up from the 8551 to 141T's and then up to

Hi Bas, I have some pictures of the 2 blue wires that goes from the HPIB board in my HP5328A, I took them for another list member some time ago. I can send them to the photos section if you are

Hi Dan, I saw the pictures and love the unit. If I had the space I would take it. Unfortunately, my electronics bench is in a corner of my living room, and I have learned it is not good to test the

Hi folks, ? ?Is there really ZERO interest in an HP 8551 spectrum analyzer? ?Given that I didn't even get any comments from this usually vocal group, and having found some replies to older posts

G'day Lee If you dont find a free copy , We have a professional reproduction quality scan at a reasonable price www.ArtekManuals.com Cheers 73 de NR1DX Dave -- Dave

AND keyboards on unused ones So I quickly found a new one on ebay for a very reasonable US $35 and $10 priority shipping, and just tried it out. It works very well on my HP 16700A. I'm very happy

Hello All Does anyone have a manual for the last version of the 410c meter solid state version. Lee.

Don, thanks for the advice. I could do this in the next days. I will post the results. Antonio I8IOV

Steve, A shunt means something in parallel. Shunt resistors are most commonly used in meter circuits. The shunt (or, low ohm resistor) is in parallel with the meter. There is no voltage

Thanks a lot of this. I just managed to get a 8568B that attenuator has some problems with the 20dB step. These instructions encourage me to open the attenuator and clean the pads with isopropyl

http://evanimages.com/wp-content/themes/evanimage/images/perfectway.php

Both the 260-A Q-Meter and the 250-A RX Meter were made under the HP brand. Development continued for a while in NJ. A 250-B was made. The 260-A was replaced by the 4342A. RX meters vanished and

Hello looking for someone who has the frequency counter Systron Donner 6054b? (I own the service manual) be able to compare the measures to repair my thanks for the help Roberto

I am looking for a BNC Fuse Holder. Anyone have one they will part with ? Thanks, Dick, W1KSZ

Hi, The key panel data entry encoder on my HP54542C scope has worn out. Anyone know of a source for replacements? Numbers on the encoder are: 9436, and 1-2-36. The part is listed as replaceable

Hi Folks, I've been installing option 011 (HPIB) on my HP5328a counter wich has a bleu wire for arming wich goes to a pin behind the operating panel. In my counter that is also the pin where Channel

Hi MK whereaboutsare you in the UK? I will have to check but I may have a spare frame, though Iam not sure what state its in. Alan G3NYK

As title, I an in the UK, so would prefer to get one from the UK or europe as postage and vat would make it expensive otherwise Aslo would like to get hold of a non-working HP141T chassis, dont mind