开云体育

Looking for manual or any information on this counter,

Hello Jack. Thank you for getting back to me. I could be interested in the 140A and also the 851B. Is there a possibility that you could send some photos of both? When your time permits please let me

Rod, Welcome to the hp_agilent_equipment group! If you happen to know anyone who lives near Norfolk, Virginia, the following gov't auction lot might be of particular

Sorry for the re-post. I had the wrong "Subject" line, the first time. ---------- Sent: Monday, May 17, 2004 10:22 AM To: 'hp_agilent_equipment@...' Subject: RE:

Jack, I have the military model designation cross-references for most or all of the equipment on your list, which I will email to you. Even better, I have spent a LOT of time ferreting-out any

Hello Morris! In the Synthesizer Driver, there is a step recovery comb generator which was driven by the 1MHz Signal. From those comb generator the ouput was filtered through a lot of filtersbanks to

Hello group (Hello Tom Gootee!!) This is my almost first post... I own a nice 4260A universal bridge, it has an issue with R3, the big rotating resistor behind the counter assembly. STUPID small

Hello Hank and other people in the HP_agilent group! Crikey, "light-years from any recognized civilzation", where on earth does that put me then? Beyond the outer universe rim? I live in a town so

Hi Robert, I have two HP scopes. One is a 130C, which I will probably keep, at least for now. The other is a 140A with 1405A and 1420A plug ins. I will sell the 140A but at this time I have no idea

Hi all, I'm new to this group, but not so new to vintage HP and other test equipment. I'm sure there are a few familar names here! I have recently found a nice clean 5100A/5110A synthesizer set and

Hello Jack. This is Robert. I have a list of H.P. Oscilliscopes I am looking for. Perhaps you might have a few of them or perhaps you could point me in the direction of where I can locate them?

I'm in Tulsa, OK..

Hank WD5JFR wrote: I'm in Klamath Falls, Oregon. That is south-central Oregon, 20 miles from the California border and light-years from any recognized civilzation. Jack

Jack Where are you located? tnx Hank WD5JFR

Greetings All, I am a new member of the group and am looking forward to an enjoyable time here. I have a large inventory of HP boat anchors which I want to dispose of. Some I want to sell as

I managed to switch off and on my trusty HP 3310A yesterday while it was connected to an audio system (not good practise!) and it now refuses to generate a signal from the low/high outputs. The

The HP 3439A has been repaired. It was C8 on A9 that had failed. I then zeroed the readout it using a calibration procedure found at https://www.logsa.army.mil/etms/find_etm.cfm. Thanks to everyone

Hello Robin I have operators book scanned-will You have them uploaded? Best Regards Hardy