开云体育

Yes, should be possible.? Note this is for a homebrew version based on ESP32 processor, not the tinySA developed by Erik/Hugen. The firmware already allows use of the main SA RF connection as a

The tinySA I designed is able to act as a signal generator. See here for the specs: https://tinysa.org/wiki/pmwiki.php?n=Main.Specification -- HBTE Files section: /g/HBTE/files Erik,

Is the tracking generator able to also ( with appropriate firmware) be a useful stand-alone rf signal generator? I had asked a question on the Homebrew (I think) group if any enterprising designer was

Another option to improve the RBW might be to use the SI4468 as the receiver.? These are ?2.52 plus VAT from Mouser UK in single units According to the datasheet the digital filters can be set to

A low cost FPGA would be my choise as well. I was unaware of the evaluation board, but would have used sata cables on my planed test board. They just are so cheap and convenient. The hackRF sdr radio

hello all, hello ismo, thanks for the answer. i have no experience with LVDS buses but i can see the numbers: 4MSaps*13bit/Sa*2channels=104Mbps the chip evaluation board uses two SATA connectors for

I concur with you. Lije wise small component purchases from sat diz the postal shipping is more around 12 to 15$, paing many international buyers. wrote:

Unfortunately, shipping things from the US to other countries is very expensive. Even shipping things inside the US can get costly, though not so much for books because there is a special postal rate

I just wish the the ship was not 25usd for a 20usd book. And if add another book it rises to 35usd!

Hi, Generally the ARRL will sell materials to anybody who wants to buy them. ARRL also has some materials on their web site that are free for everybody to use. There are or have been some items that

Thanks Doug, I could order for a book. Many thanks for the clarification. Regarfs Sarma vu3zmv

How about explaining your specific issues?? Is this not a forum for discussing homebrew test equipment?? The very first chapter has a section on measuring RF power including building power meters

I am not a member and had no problem ordering.

Or SPAM victims ....

Only for arrl members i supose Sarma vu3zmv [email protected]> wrote:

Great opportunity to get this classic book. Experimental Methods in RF Design (Classic Reprint Edition) ( http://www.arrl.org/shop/Experimental-Methods-in-RF-Design-Classic-Reprint-Edition/ )

I have done some datasheet reading on the AT86RF215M, but mostly as a solution for low cost sdr uses, not as a spectrum analyzer IF :) The annoying bit about it is the interface via which the IQ

hello all, i just discovered this group and their efforts... congratulations for the SA analyzer and its fantastic price. you have killed to us the desire of design/build our own SA, hi hi i can not

The V2.0 panels have been loaded and tested in the Tracking Gen mode. Very promising.? Note no shielding was fitted anywhere in this test. (with some small mods for chip selects, V1.0 panels should

After being on hold, my new "V2" panels have arrived.? These are slightly modified V1.0 versions to provide for a tracking generator option once software is fully developed for it. Glenn vk3pe