Re: Tracking Generator for tinySA
|
Thats a winner...
Dr.?William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton - J68HZ Soufriere, St. Lucia W.I. Rent it: www.VillaGrandPiton.com
email:??bill@... ?
toggle quoted message
Show quoted text
On Aug 23, 2020, at 11:36 PM, Glenn <glennp@...> wrote:
?The V2.0 panels have been loaded and tested in the Tracking Gen mode. Very promising.? Note no shielding was fitted anywhere in this test. (with some small mods for chip selects, V1.0 panels should work too.) Comparison with my Rigole on testing a junk box High Pass Filter look promising.?? The roll-off at the high end maybe due to the Si4342 module LPF filters which can be bypassed. Will look at that later but the concept is proven.? It uses 1 x control board (top of the panel and two x RF boards, so two panels are needed. Many thanks to M0WID, WA2FZW & G3ZQC for software. Glenn <simpleSA_TG_mode_of-bench-LPF.jpg>
|
K9HZ