开云体育

Yeh, when I look at it these are definitely the Gemini servo cover standoffs because the #492 standoffs are a lot longer in length.? But they all use the same 6-32 thread though. -- Chip Louie

Yeah I'm thinking that? ....see here ( /g/Gemini_users/table?id=6040 ) item #7.?? #6-32UNC Remember folks....this information is already easily available by search or

Maybe motor cover standoffs for the #492 steppers or Gemini servos?? I have both and they seem so familiar.. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric - South

Luca where are they from. ?The motor covers ( https://store-losmandy-com.3dcartstores.com/svgbc ) ? Or inside the Gemini ? cheers -- Brendan

hi all, anyone can tell me which thread is it? Here in Italy we aren't so friendly with withworth threads. thanks, Luca

I was reading Hooking up a Gemini-1 to your PC or Laptop for GoTo and Autoguiding pdf. The mount setup shown had shelf and I’m asking if there is a drawing other dyi information available? Or other

Depending on which G2….the “tall boys” did get cracks around motor socket connections on the PCB. ? Easily fixed. The mini’s use a more readily available better DIN socket that’s easily

Hello, I had the same thing happen when i turned on the power for my Gemini 2 GM8 mount that the RA would run away at full speed for 2 different reasons. One time was because my power cable to the

Hopefully got one on the way. Thanks for everyone's help :) Paul

Agree with David - didn't see his response in time :(.? these are $27 in the US, but after shipping and VAT, probably best to purchase in UK. Will

Paul, Here is the datasheet. I will check my sources and get back to you. Cheers! Will [email protected]> wrote:

Paul be aware that you may also have damaged the main board axes PLD encoder IC. ?It reads these encoder pulses and compares them and switches between 1x and 4x resolution mode. just sayin. Oh

Hi David, I'm with you on the F00 variant. I'll order from Digikey. Thank you for your help, Paul

You can replace with HEDS-9100#F00 or HEDS-9140#F00 http://oemsecrets.com may help you find a stockist – looks like Digikey is your best bet.

Hi James, My guess is that it is a coincidence and there is nothing wrong with the actual hardware based on the fact that it slews and GOTOs fine. Maybe you should look at the system that's NQR.?

Hello Group, I have a problem with a runaway SVM-HT motor on my Gemini 1 L4 G11 mount. Basically when I turn on the Gemini, the motor just runs away at full slew speed. It got very close to disaster

Thanks Chip, My G11 is the CG11, when Losmandy and Celestron combined their product offering way back when.? When I ordered my Gemini 2 also got new servo motors and new gearboxes. I pulled it

The first thing to check is that your Gemini settings are still correct. For example, HC mode should be Photo or All-Speeds, otherwise no guiding will happen. Then, check that you have the correct

Thanks Paul, The PHD2 autoguiding was working near perfectly until this happened.? I had just finished over of hour of imaging a planetary.? When I wrote that RA guiding was a problem, to be clear,

James, Limits!? Also look for hidden damage.? The servo motor fasteners often damage the gearbox threads and the backing plates of the original G11/GM8 mounts were heat riveted and tended to break