开云体育

That sounds like you need to send your Gemini-1 controller plus motors and cables to one of the repairers. Michaeal Herman in USA, Bren Smith in Australia, myself in the UK. See: <

Roman, Your Gemini1 unit may be damaged, or one or both motors, or their cables, also damaged. You already tried all reasonable efforts to figure it out. You should send your Gemini1, and it's motors

Hi David , Thanks for response . I did it so many times , with new? cables for motors and hand control . In the middle of cold start mount beep and Tracking Stopped . RA motor Motor Stalled and?

Hi Roman I have two Gemini 1 Level 4 motors for sale if needed. They run fine, I changed when I went to Gemini2. Chuck ________________________________ Sent: Wednesday, October 20, 2021 12:37 PM To:

You should be able to power off, release the clutches, move the mount by hand to CWD, tighten the clutches and then power on with a cold start. All should be well after that. If not please let us know

Hi Ron, I don't do plate solving, but I really should give it another go now that I have much better cameras than before. So my routine is a bit different, I think, than most. Maybe call it caveman

Hi , Accidentally left running? my G11 with Gemini 1 Level 4 . I come back after few hours and m RA and DEC run to the end ... and stack . Now I do not have control on my mount and motors run strange

Usually the software has a centering routine which automates the process of goto, plate solve, sync, goto until it is within your constraint parameters If there is no centering routine in the

sorry now I realize that the value of Platesolving is greater than the Gemini modelBut if the resync after the platesolve is off how do I proceed with alignment?thanksRon

Thanks for the quick reply Brian !OK I guess I understand now that the model in Ge

Hi Ron My first question is: are you sure you need to do that? if you are plate solving and centering via software, you do not need to build a model in Gemini [email protected]> wrote:

Hello during this full moon :) Since I have a permanent setup I thought that I would try to build a real accurate model in Gemini 2 and continue to add new targets as the year progresses from this

Hi Michael, I usually remote operate my 811 from inside the house via WIFI with Tight Vnc. Things usually run smooth for me, but now and then things get wonky. With my first mount (Celestron AVX) I

I’ve not seen full sized 6 pin DIN cables online – only mini-DIN and who knows what type of cable they use. D Sent: 14 October 2021 08:51 To: [email protected] Subject: Re: [Gemini_users_io]

A follow up question. When you say that the 6 pin din consists of twisted pairs. Does that mean that it's not a normal 6 pin cable that I can buy online?

Have uploaded the PHD log Thanks all

Yes, i got you there I use PHD Log Viewer and PEMPro log viewer, which i’ve found to be a lot more informative and helpful. If you find PECPrep useful, fantastic brian valente Losmandy Astronomical

PECprep re formats the PHD log file to this file. The data is unchanged. The reformation makes fir less steps when viewing the file later in PECprep. PECprep is proving to be a valuable tool in

I don't use pecprep/eqmod so I can't read these logs, even though it says PhD. wrote: Brian Brian Valente portfolio brianvalentephotography.com <http://brianvalentephotography.com>

Out of interest, I have attached this evenings PERecorder log from PECPrep.? It certainly shows some bearing case issues.? I have the new bearings arrived today so I look forwards to changing them