开云体育

The current weight supported by the mount is 12 kilograms. It is not too much to cause it to lock up when turning. I will have to disassemble the mount, make sure there are no screws that are loose or

That explains it. Thanks a lot for your reply and helped a lot. Scott MefferdSent from my Galaxy

The GM811G is like the G11T.? ?It is a way to get a little more payload capacity without making the full jump to the next bigger mount. A little more payload for a little less than the full price of

G 811 the same as a G11

Thanks for the answers Paul. I've been having problems with the G8/11 for a while now and I'm feeling a bit frustrated. It's probably due to a lack of knowledge about the mount. I just can't seem to

I don't see anything in the screen shots that could cause this problem. Also, between version 1.1.25 and 1.1.28 of the driver there were only two changes, and these should have no effect on the

Thanks for answering. I tested the connection to the Gemini.Net Ascom driver (1.1.28) and it actually did not connect. I don't know where I could have the problem. However, I have loaded version

I doubt the problem is with the ASCOM platform -- it doesn't have anything to do with the connection to Gemini. The ASCOM driver does, and I believe you didn't change driver version, correct? Instead

The version of Ascom that I have installed is 7.02. I understand that the fix that Paul Kavansky says was made in 7.01. Is it like that?

I believe that this is an ASVOM issue Paul Kavansky wrote in Gemini ASCOM Forum this following So might be best to read this on Gemini ASCOM forum

Hello. This is the first time I write on the forum. I have a G8 11 mount and gemini 2 level 6 (1.1.28). So far I have been running Ascom 6.6 and Nina 2.2 without problems. The problem arose with the

Maybe don't blame the well tested and proven Gemini.net ASCOM driver?? Could you try a different app to GOTO?? Maybe Stellarium or other popular? planetarium app?? I have been using the Gemini.net

Hi, Thanks Joe for your answers. To answer your suggestions and to complete my information: The error notified appears when I want to point my telescope at a target with the Prism software mapping

It's saying your computer was unable to connect to the serial port that Gemini was configured for. That could be as simple as the serial cable is unplugged, or Gemini is not powered on. Other things

Bonjour, Que signifie le message ci-dessous s'il vous pla?t ? Je ne peux plus pointer de cibles. Merci. Bien cordialement. Jean-Bernard Pioppa

Well, shoot, I didn't even get to weigh in :-) Of course, I didn't need to, I had all the same suggestions as others had posted.? With my antique Gemini I I've found a bad conductor in the cable

Problem solved, found a broken wire in the DEC motor cable, soldered it back and everything's working fine now. My best regards Paulo Casquinha De: [email protected]

Hi Paulo, First thing I’d check is to make sure the motors are connected correctly. Maybe Dec is connected to RA and so Dec is trying to “track” the sky. If not the problem then some

Hi I have a Moutain instruments MI 250 with a Gemini 1 L4 system and last night when I power up the system with the standard 'warm startup' , the DEC motor starts running at a slow pace and it does

Hi Eugene, Are you thinking of upgrading to Gemini-II or Gemini-I? This group is primarily for Gemini-1 users, so you may get more from the Gemini-II User group if that's the version you're thinking