开云体育

It’ll be 1st version that needs soldering down. ? Maybe try use a small plastic “spludger” (use to take iPhones start) But sounds as if touch screen overlay is dead and you have to replace the

Ken Where on the planet are you? I have some of the touch screens but I probably isn’t economic for you unless you’re in the UK David Sent: 24 February 2025 14:58 To: [email protected] Subject:

I have a G-11/Gemini II that has not been used for a number of years. I recently decided to return it to active service given some new observing interests, and I found out that the HC won't respond to

You may find it helpful to add an entry for gemini in your hosts table. Location in windows is \Windows\System32\drivers\etc\hosts file. If you have a static address for the gemini you should add it

Hi All, I was able to reach the Gemini 2 through my PC by directly connecting the Gemini to my router using an ordinary ethernet patch cable, so everything is now up to date. Switching to terrestrial

Thanks for elucidating that. I stand corrected. Obviously I meant a switch. And he actually has one already he can use if he decided to pursue this path. F. X. Flinn e:

Hmm, actually no.? As you must know the topography of a hub is quite different from a switch.? Hubs have been obsolete for decades, packet collisions made them very inefficient and slow on active

You will probably get ticking in terrestrial mode as the system has no encoder signals. ?But it won’t be trying to move the Ra etc. the ticking is warning of motor stall (Aka no encoder signal

I connect both of my HGM Titan and G-11 with Gemini 2 directly to my PC using a standard Ethernet cable. You just need to make sure that the IP address is set up correctly. I've done it with the

ethernet switch = ethernet switching hub may depend on when you started doing local area networks ... for me it was 1989 F. X. Flinn e: <chair@...>fxflinn@... | m:802-369-0069

Hi Don, You do not want to use any kind of hub, you want to use an Ethernet switch.? The 10/100/1000 Ethernet switches are cheap as peas, just buy one with as few ports as possible, you only need 2

Chip Louie, Thanks - I think the cross-over cable adapter is a good way to go. I probably was not completely understanding the role of the cross-over cable described in the direct method instructions.

The only caveat I have for you is about the 2.5 GB business. If your subscription is for gigabit speed and your router has a 2.5 port and that port is the one with the patch cord to your computer's

F.X. - Thanks for outlining this possibility. I can see that it could improve immediately and allow more connections down the road. I have a not-so-old Netgear 5-port switching hub so I can try this.

Hi Don, As others have mentioned the ticking so

I have ethernet cabling running from the house to my SkyShed Pod observatory and a dual scope setup with one controlled by a mini PC running NINA or SharpCap and the other controlled by an ASIAir.

Hi Paul, Thanks for confirming that the ticking sound is no concern. I think you are right about connection configuration, so I am focusing on that now. The PC has 2 ethernet ports, one 1Gb

Hi Conrad. The PC is a NUC Chimney Rock (LLN11CRv7), running Windows 11 Pro. I chose it for its size and 12-19V power accommodation (most NUCs are 19V only) so that it might reside at the mount, like

Thanks Brendan - I will definitely switch to terrestrial mode. Don

Thanks Jonathan, I will try a USB connection. I didnt know about using terrestrial tracking to silence the clicks - will try that too. Don