Paul,
?
I used Windows uninstall of the Kiel software and reinstalled the package prior to sending the first note.? However, with the suggestion to repeat I found an issue occurred by my using the previously saved installation files.? It seems to install correctly requires going back to the Keil site and entering the same use request again.? I could be wrong, but it appeared their downloaded files require an active Keil server to support the install process after the download.? I tried this installing in a sandbox quite a few times to prove this to myself.? Then I reinstalled into the workstation environment by new request.? Pretty sure, assuming the software is now proper to at least what existed on the first attempt.
?
Now looking at the re-installed Kiel debugger,
?
going down the Keil Debugger check list.
?
?1. Yes
?
?2. Not exactly, this shows
?
?
?3. Yes
?
?4. No
?
?
During this, I am connected (red strip at J10 location), G2 has power, RealView_Ulink_2 shows USB status lighted, USB connected to the workstation. {All as before when it partially functioned.}
?
Perhaps after the Flash step on, the first attempt, the RealView unit failed??
?
In any case, If I attempt the download step now under Flash, it reports
?
?
?
I appreciate your insights, thanks
Doug
?
?
