开云体育

Thank you Andy, for your excellent work too. Panow sv1acw [email protected]> wrote:

Hi Panos Thanks for joining the group. Regards Andy G6LBQ

Thank you for accepting me into the G6LBQ group. It seems to be a fascinating group fulfilling the real amateur spirit of radio as ITU refers to, establishing the radio-amateur service. I guess I am

The following files and folders have been uploaded to the Files area of the [email protected] group. * /G6LBQ Irwell Transceiver/STM32 Si5351 VFO/Oscillator & Multiplexer

Hi Adrian Unfortunately I do not have a MK1 linear board to hand I can test though I may have one packed away in my attic and if I get time over the weekend I will have a look. To use the Mk1 linear

Hi Andy Thanks for the reply. I have been using the instructions dated 10 April 2013 to set up the PA. Could you confirm a few things please ? Referring to the instructions above, my measurements

Hi Adrian Sorry to hear you are having problems with your MK1 Linear amplifier. I am not aware of any issues with the MK1 linear apart from people over driving it when used with the MK2

Hi all Having just resurrected my G6LBQ Multiband BITX transceiver I discovered a problem with the PA. Historically I had issues with a splurge of carrier and stuff as I went from TX to RX. Now

Haha I'm fine mate, qnd yes still have radio close by and fingers crossed I will have a huge shed shack by summer so looking forward to getting stuck in again [email protected]> wrote:

Hi Everyone I have just posted details on my blog detailing the Irwell transceiver modulator. The web link to the post

Hi Paul Good to see you are still part of the family :) Doing okay here and hope all is well with you and your family. Regards Andy (G6LBQ)

Hi Andy, hope you doing ok mate?

Hi Andy, Your update to the IF amp/agc looks great. Had few questions as outlined below. If I were to use the AD8361 outside of your agc circuit as a AM demod what is signal range in dBm that it

Hi, I have conducted measurements, but I certainly have built a dual conversion IF sub module. (See photo below) [Image.jpeg] Kind regards Rahul.S

Hello AP2RF, I have not done comparative tests in the laboratory, but the advantages and disadvantages of one or the other are also highlighted by the respective data-sheets ... If your desire is

Hi Riffad I have played a little with the AD831 mixer and in general it is a nice device, I used a couple of the mixers in a dual conversion receiver and they performed okay. Being an active device

Ad831 mightvwell work for qo100 upconversion. I saw people using it. Ade1- ask is working well upto 800mhz Regard Sarma vu3zmv

Hi Friends, Its AP2RF Here, Did anyone try AD831 Mixer Kit for HF Bands?? Any comparison with ADE-1-24 Mixer? Which one has a better Low noise figure,? low conversion loss and IMD?? Kindly share

I have now uploaded the JA2GQP source software for the STM32 Si5351 VFO into the files section. This is the software that I have used as a base for the Irwell Transceiver VFO. Regards Andy

Hi Rahul I used the TCA9548A Multiplexer IC in my VFO which has 8 channels, the PCA9540B only has two channels which is not enough for my VFO as I am using 3. Still the PCA9540B is a useful IC so