开云体育

Are you wanting to tune AM with the main VFO dial?? Make sure menu setting #04 "AM&FM DIAL" is enabled.That setting defaults to 'Disabled'Mike

Curious why I can't tune in VFO when the rig is in AM mode. TX de WL7BCT Mark Bethel, Alaska AP90bs

Just take the knob down to your local hardware. They can hook you up with a screw and tool to do the repair K3CLT Chuck Tobias

Hy In the Service Menü There ist a setting for the 5watt Output. Just reduce the 5 Watt setting And enjoy 73 Andi DF1HF -- Diese Nachricht wurde von meinem Android Mobiltelefon mit GMX Mail

...but it would need to be switchable because you don't want to attenuate the receive side. Mike / W8DN

My 857D's main tuning knob fell off the shaft.? Looks like the set screw loosened just enough for it to slide off.? Anyone know the set screw size and tool size to tighten it?? My smallest metric

Just thinking out loud ..but I suppose you could put an RF attenuator in line between the radio and antenna (??)Mike

Hello fellow F-857 enthusiast! I have a quick question....right.? ?Is it possible to reduce the power to less than 5 the current minimum? I would like to be able to start with a meager 1 Watt in

Thought I would ask the group for ideas on these issues with a new to me FT-857.? The input voltage displayed on the screen wanders up and down between 12.5 V and 14.4 V.? The actual measured

Most EEPROM's I am familiar with (including those built into microcontrollers) typically have about 10,000 write cycles as their limits. Firmware for EEPROM's/ microcontrollers that I have written

Yes I did find the HRD notifiocation regarding removing the agc etc commands at Yaesu's request due to them apparently damaging a ram chip (I think). + Many years ago, KA7OEI discovered an

Node Red tcp request talks to a rigctld server I have connected to the radio. I rigctld direct cat requests are possible in W ..... w ....... formats.

Hi Adrian, I found this on the net which has a full list of all the CAT commands. https://www.manualslib.com/manual/875752/Yaesu-Ft-991-Cat.html?page=10#manual I have heard that some of the

While you are looking at Device Manager, unlpug the USB cable from the TT4. One of those COM ports should go away. Plug the USB cable back in and it should come back. That will verify which one is

I think those commands were removed because it was shown that certain aspects of remote control on the FT-8X7 series radio shortened the life of the radio. Yaesu came out and said not to use the older

Not sure this is what you need since I don't do CAT, but I had a table of Supported Commands in my records that has | Buttons: On/Off | AGC | On = I-00A8-20-20, Off =

Hi all , are 2 different things : the baud rate from the computer to the TT4 and baud rate over the air rate, some of you responded for the second - always 1200 on 2m , correct , but I guess the

When I go to Device Manager I show a com 4 and 5.? Both are listed as 9600 baud.? When I go to APRS-IS software it shows com 3 and com 4, so I assume com 4 must be it.? I set Device to com 4 and

Hi Stan, That’s the radio side, not the serial port side. 73….Eric VK2VE. Sent: Sunday, 29 May 2022 07:41 To: [email protected] Subject: Re: [FT-857] Baud Rate For APRS #APRS Mine is

I see. Missed that critical point. Thank you for the clarification. stan