开云体育

Sorry, the headset has been sold. 73 John AF5CC wrote:

Headset still available? Brian? ? N7BMH

I am pretty sure it’s audio. Thanks Justin Sent: Thursday, June 16, 2022 8:40 AM To: [email protected] Subject: Re: [FT-857] audio pitch too high Are we talking audio high frequency

Thanks – I think I found what your talking about and will try it . Justin Sent: Thursday, June 16, 2022 8:32 AM To: [email protected] Subject: Re: [FT-857] audio pitch too high I believe

Are we talking audio high frequency too bright or are we talking off frequency? It could be either. There could be a TX shift that is not zero beat with the person he is talking to. Or he tunes where

I believe there is also a tx band pass filter in the menu.? Set it to low pass and see how that does.

I have for sale? a WGA TR-2000 headset for Yaesu radios that use a RJ-45 8 pin mic plug like the FT857.? The plastic tab has broken off the mic plug, but it seems to stay in the mic jack ok

On my mic (a MH-31 stock mic for the FT857) there is a switch "1" or "2" on the back of the mic, which changes the sensitivity to high, or low, audio frequencies. I don't know if the MH-59 is the

Thanks John - what kind of mic do you use , is it the stock mic or other ? Please specify. Thanks Justin

Too high in tone/pitch in either mode? Both modes, both LSB and USB "high"? Hmm. I am not aware, and stand to be corrected, of a setting for that. Just did some word searches in three editions of

HF USB and LSB -- thanks for the reply

Hi Justin, Which mode? 73, John VA7OTC

Justin, the noise floor into a 50 Ohm resistor at room temperature into a 50 Ohm system should be -174 dBm/Hz. If your rig has a noise figure of 10 dB (this is a common value with pre-amp on at 50

I've gotten complaints that the audio pitch is too high , is there a way to lower the pitch . I am using the MH -59 A8J mic. Thanks Justin KB2ZVD

What should the noise floor be going into just a 50 ohm load , no antenna connection ? Thanks Justin KB2ZVD

had mine just repaired some time back and sent the unit back to my tech here, he sent for the part from YAESU PARTS and it took 2 weeks to do, my tech replaced the digital display, and apparently,

Thank you for checking.? Yes, went to a HW store after work and picked up a set of small (and not so small) hex keys, 1.5mm worked. (Smallest I had before trip to the store was 2mm). 73 Steve KS1G

Hi Steve, Just checked on my 857 and it is a 1.5mm hex key. 73….Eric VK2VE. Sent: Monday, 13 June 2022 21:04 To: '[email protected]' <[email protected]> Subject: RE: [FT-857] Main Tuning Knob

Hi Steve, Off the top of my hear I think it is a 2mm metric 73….Eric VK2VE. Sent: Monday, 13 June 2022 00:59 To: [email protected] Subject: [FT-857] Main Tuning Knob Setscrew size My

Your right! ?That’s a great idea. -- Rafael / NN3RP