Hi all.
I'm working on getting this JV2 back to factory. Not a restoration just functioning. And I'm a rookie so its quite the learning curve.
I have a lot of chaos with the voltages on this unit and one item I am stumped on is the R57 shunt > picture + schematic attached.
Why would the voltage be the same on both sides? Unless then repealed Ohms law I should have a lower voltage on one end?
Its a 5.1 Ohm that measures about 6.1 and I get 3mV across it power on. DC Voltage is -67? on both sides with T2 or T1&T2 on.
What am I missing? Can I replace it with a 5 Ohm 2 Watt and be fine ?
