开云体育

The shipping is for air. Shipping by air is costly.? USA DHL Estimated Delivery Time: 6-13 Days. If was buying I would use sea shipping the price drops The only draw back it takes 6 to 8 weeks Any

??? ??? was that link to the Chinese site ?? that will change shipping ??? ??? animal

I think that shipping more one. We both have one but someone look would they have contact the seller. Today so far I for two selling the mill and you need try make a deal for shipping. The last one

It looks smaller than the Big Red (HF 42976) but the real killer is the shipping charges – over $1K for shipping to the US. * Bob Headrick Sent: Sunday, June 7, 2020 11:00 AM To:

But shipping at $368? Ouch. I was able to find a big red and did the fine feed conversion last month. Glad that I was able to save some of the files from the old Yahoo Group.

Here is big red in blue under

Here is photo of new Big Red?It is still a good mill for small shop needing more than a minute mill.Still under $500.00. I have own my since 2004 and fits in my 10 x10 [ 3 M x 3 M] shop.?The biggest

Today it is BIG GREEN less than

Yes. I have found on closed end slots that it is best to drill each end slightly smaller then make multiple passes top down with a four flute. Victor -- This email has been checked for viruses by

I use old mills with lot of slop Typically I apply a little of table clamp . If cutting a 1/2" slot make the first pass with next size smaller end mill Then finish with 1/2" end mill Dave

Found the article! https://rick.sparber.org/ZABG.pdf

Hi Peter, I have read of people using gas pressure struts like those used to hold vehicle hatches open. I haven't seen an example however.

I cannot add directly, but I have a G0463/Sieg X3 that makes a noise when cutting steel with 1mm depth of cut with 12 mm cutter, only reducing the feed and tuning the speed brings it down to a

Hi, Thanks for accepting me to this group. I have owned a RF30 Metric R8 for nearly 20 years. Recently been try to improve the machine, add power feed and resolve issues with the backlash in the z

Dave I think I have it figured out, I just installed the controller in a bad place to get at its under the bench so, I bit the bullet and crawled under there yesterday, and pulled it out.. Did some

Can you post photos of your trouble Just got email today Dave

Dave I sent a reply from the email you had sent me, not sure if you got it, or if it went, so let me know if you did receive it.. Thanks gary

I use a 1/4" belt on my x2 got rid of the plastic... much better I haven't used the mill in a while but went out to rub it today, of course can't get the spindle to work, have a kbws controller,

A while back I mentioned selling my big mill in preparation for moving from 120V land to 220V land.? Well, that's sold and assuming the stay at home stuff gets lifted, we're still planning the move

Hi what size belt are you looking to use. I'm in the process of making one for a x2 type mill central machinery. From my measurements there isn't much room to go with a much larger belt. I have