开云体育

All I've left to do on my Lot? 4 is tend to the spindle bearings. If I tighten the caps the spindle turns with? a? lot of drag.I was wondering if there is a recommended torque for the caps and if

Thanks, DennisI thought that might be the case.? The back gear brgs are very tight and lack the set screws (one more thing to make) tho the shaft moves as it should. I joke about hammer mechanics,

Ok Larry one your Dalton there suppose to be two square head screws that are on the under side of the head stock casting that supports the back gear.? The back gear shaft rotates in two split

I apologize for hijacking this thread.? I seem to have misplaced my password book.I need to swap out the existing timing belt on the lathe with a longer one.? This requires removing the back gear

Hi Colin I would be interested in this item I am located just outside Ridge town. Robert Lawrence 226 376 7912 Thanks Bob Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

Yes sir

Selling my Dalton located in southern Ontario, see image and reply to this post if interested. Colin

Ok posted three pics still learning how to use this chat Matt

On Sat, Aug 29, 2020 at 08:40 PM, Dennis Turk wrote: On Sat, Aug 29, 2020 at 08:40 PM, Dennis Turk wrote:

There is no groove on my counter shaft so I guess a washer was used.Back in the days when horizontal mills were common, I would position the milling cutters using spacers of various widths.?? These

This is a message that came from a hacker that hacked my email account roster.? If you get one and respond to the email address you will be ask for money for some emergency.? The Ukrainian hackers

The bead chain used on the spindle has no master link it has to slide onto the spindle from the end of the spindle on assembly.? Also the bead chain runs in a small radius groove cut in the spindle

out of curiosity, will a mill arbor spacer work?? They are easy to make.? Also, can a pull chain be used?? Will the master link pass over the shaft?Larry

post a picture of your pulleys and let see if they are the correct ones. Dennis

I've ran a lathe certified machinist but I havent ran a manual lathe in years so memory is rusty plus never ran one this old

No I havent checked them I figured it was a babbet bearing I'll definently check them thanks yes I'd like to see a picture and dimensions of the wire washer I do better with visuals when it comes to

Sorry i didnt know you guys were gonna respond!!! Yes im doing the gingery machines ( little bigger dimensions on a few parts) just for the adventure and the skills/knowledge to be gained.. But i

When I said the countershaft turns 400 max that was if you had both original cone or step pulleys that you don’t have. The spindle can be ran up to 1500 or a bit more providing the lubricator

Where are you located? Ralph Joshua lee Franklin wrote: -- PLEASE BE KIND TO YOUR EMAIL FRIENDS Before forwarding please remove all email addresses and use the BCC option to add your contacts.

I too have a good condition 9? inchby 4 foot. I love my lady it has just about everything in that it was supposed to come with except for a stand and a tool holder which I only cut soft materials