The bead chain used on the spindle has no master link it has to slide onto the spindle from the end of the spindle on assembly.? Also the bead chain runs in a small radius groove cut in the spindle bearing journal.? Not sure what you mean by using a mill arbor spacer.
Dennis
On Sunday, August 30, 2020, 01:43:19 AM PDT, L Leonard via groups.io <metalmechanic@...> wrote:
out of curiosity, will a mill arbor spacer work?? They are easy to make.? Also, can a pull chain be used?? Will the master link pass over the shaft?
Larry
On Saturday, August 29, 2020, 11:40:23 PM EDT, Dennis Turk <dennis.turk2@...> wrote:
post a picture of your pulleys and let see if they are the correct ones.
Dennis
On Saturday, August 29, 2020, 07:48:57 PM PDT, me myself via groups.io <probodybuilder21@...> wrote:
I've ran a lathe certified machinist but I havent ran a manual lathe in years so memory is rusty plus never ran one this old
Dennis Turk