开云体育

I'm ready to mount the motor on my Lot 4 (2050). the former owner ran the jack shaft at 575 rpm tho, to be fair, judging by the lack of chips evident when I bought it, not for any length of

I had fun making the bench on mine.? IT is the lathe on this home page, the green stand. If you search through my pics that I uploads you will see some decent photos of what I did, but I basically

Most any design will work. My bench is a 2x6top with a nice piece of varnished cabinet grade plywood over the top- supported by 2x4 frame. Although it is nailed to the wall on two sides, so super

I'm finally setting up my B-6 I remember a while back there was a discussion on the type of bench to use in a small shop. ? I've been unable to locate the thread. If anyone can help I would be most

Dennis I have seen your other pedal powered Dalton. It may not work well, but it is STILL a thing of beauty. -As is the one shown here.

Hi All Well I am back on the site thanks to our moderator Dan.? So I have some pictures and info on the lever operated collet closer used on the Lot 4 and Lot 5 Dalton's.? The only one known of is

Dennis, I shot you an email. I am definitely interested. -Trenton

Here is a picture of the tail stock I have or should say two that I have.? The one in front is a later model one used on all Lot 5 lathes as well as later model Lot 4 lathes with the two piece end

Hi Pete Send me your address in a personal email and I will send a gear and a set of drawings off to you.? My Drawings maybe down at my coast place and if so will have to wait till the middle of the

I have not had a chance to go over to my storage building as yet but should do so today.? Not sure I have a tail stock but will look.? I may have a project lathe that will never be finished and

Hi Dennis, Thanks for the quick reply.? I would like to making my own and the only part I can't make right now is the gear.? Let me know what the dial gear and drawings would cost and how to pay

Dennis, I am assuming that you don't have anything laying around? Figure I should double check before I try to retrofit something else onto the thing off ebay.

Hi Pete No thread dials and no plans on making more.? I do have dial gears for the lot 3 4 and 5 lathes as well as a set of drawings.? Let ,me know? if interested in making your own.? Dennis

When I hear “The Turk” I think of the famous chess playing Automaton

I think it is the Great Turk, no the old Turk :D

Hello Dennis, At one time you were making and selling thread dials.? If you have some in stock or plan on making more please let me know how much one would be. Thanks, Peter Inglis Loudon, TN

Thanks for checking Dennis! Also, many thanks for setting up this whole community. It has been of great help with my restoration efforts on this lathe. -Trenton

Hi Trenton Just got home today and will look and see if I have any tail stocks left.? May not I have provided a couple for Dalton guys from my parts lathes. Dennis

I think you Have to unsubscribe, by clicking the link on the bottom of the email

Hello All, Fairly new to this forum. I recently came into the possession of a Dalton Six type B-4. Lot 5 No 256 to be exact. It just so happens that this lathe is missing its tailstock. I have been