Re: Spindle nose thread protector
|
Dennis ,,? Yes sorry should have said it was a 30"? bed ( Wish it was a 36" one-- oh well happy with the 30" :) ) ---Now the other question -- I do not have a Steady Rest will a South Bend one work or will I need to try and make something that will work ? or do you have one you might want to sell ? I know this is something that is just not out there that is easy to come by.? I am open to any ideas also.
On Monday, July 3, 2023 at 11:04:46 AM EDT, Dennis Turk <dennisturk448@...> wrote:
Terry, I don't see a problem with what you?want to do.? It would be even better if your lathe had a 36 inch bed but guessing yours is a 30 inch.? Holding the cam at one in with the chuck and supporting the cam with a steady rest at one of the bearing journals should work just?fine.
Dennis would a steady rest work what I have in mind removing the tailstock or could I do damage to the B-4 lathe ? The total overall length of the Cam is 18" end to end.
Hi Terry As to your question about follower and steady rest, yes Dalton provided steady rest for? all models of lathes they produced.? I have one for each model I have.? Lest I think so.? You guys have no idea of how much Dalton South Bend and Atlas stuff I actually?have. Also have your name and address on my list of thread protectors to ship off. Post office has been out of small flat rate boxes so as soon as I get some I will be sending your thread protectors off.?
Hello Dennis , Hope you see this. I sent you a email ( Your new email address) about the thread protector awhile back guess you did not get it. Do have a question though did Dalton make a Follower Steady Rest ( Think that is what it is called ) for the B-4 Lathe ? If not what might fit .or make fit ?? I was thinking about polishing a small Diesel Cam to check the lobs ( in Granny Gear ) but since the B-4 is so short thought would take the tail stock off and install one---- again only turning in Granny Gear to polish. Good idea or a bad one ?? Terry St.Pete Fl.
Hi all.? ?Well looks like Dan got things fixt as I just logged in and this is the first post I have made in a long time.??
As to spindle nose thread protectors I have a bunch of them and for $15 and shipping I will send one to you.? These are for the 1 1/4 - 12 spindle nose on the Lot 2 3 4 and 5 and also on the TL lathe with the same spindle nose.
Dennis
|
