Re: Spindle nose thread protector
|
Hello Dennis , Hope you see this. I sent you a email ( Your new email address) about the thread protector awhile back guess you did not get it. Do have a question though did Dalton make a Follower Steady Rest ( Think that is what it is called ) for the B-4 Lathe ? If not what might fit .or make fit ?? I was thinking about polishing a small Diesel Cam to check the lobs ( in Granny Gear ) but since the B-4 is so short thought would take the tail stock off and install one---- again only turning in Granny Gear to polish. Good idea or a bad one ?? Terry St.Pete Fl.
On Tuesday, June 20, 2023 at 08:29:11 PM EDT, Dennis Turk <dennisturk448@...> wrote:
Hi all.? ?Well looks like Dan got things fixt as I just logged in and this is the first post I have made in a long time.??
As to spindle nose thread protectors I have a bunch of them and for $15 and shipping I will send one to you.? These are for the 1 1/4 - 12 spindle nose on the Lot 2 3 4 and 5 and also on the TL lathe with the same spindle nose.
Dennis
|
