开云体育

  1. DaltonLathes
  2. Messages
Single Messages Topics Expanded Polls

Re: spindle nose thread protectors

 

Dennis ---This is Terry from St.Petersburg Florida hope all is well at your end . Not sure if this will get to you or not but was wondering do you have any Spindle Nose Protectors left ? If you do sure would like to get one from you.

On Friday, January 14, 2022 at 07:18:42 PM EST, Dennis Turk <dennis.turk2@...> wrote:


No Chris the spindle nose on the Lot 2 3 4 and 5 are all the same. ?I may have just given a bit of extra clearance on for the registration shoulder behind the thread.? When the spindles are brand new the OD of the thread will be the same diameter as the registration shoulder but over the years of use the threads tend to wear down so they seem smaller in diameter than? the registration shoulder.

? Dennis

?

From: [email protected] [mailto:[email protected]] On Behalf Of chrisser via groups.io
Sent: Friday, January 14, 2022 4:00 PM
To: [email protected]
Subject: Re: [DaltonLathes] spindle nose thread protectors

?

Received one of Dennis' spindle nose protectors.? It's currently the nicest part of my Dalton.?

Thanks for making them available, Dennis.

I noticed the ID has stepped threads with the smaller set fitting my spindle.? Is this so it fits the Lots 3-5 with the smaller threads and the lot 6 with the larger or is there another reason ?

Anyhow, some before and after pics...
Join [email protected] to automatically receive all group messages.