Re: hrust bearing
|
Thanks. L
On Tuesday, August 11, 2020, 8:28:21 PM EDT, Dennis Turk <dennis.turk2@...> wrote:
Larry order a set of thrust washers and a needle? bearing from MSC or Mc Master Carr to go in place of the red thrust washer under your adjusting nut.? Total thickness of the two thrust washers and bearing is .139 so should take up the play you have.? Also allows you to set the spindle end play at zero and also will not let the left head stock bearing heat up like they like to do if you have the plain thrust washer set for close to zero end play.? UHMW is worthless as a thrust washer also.? It works OK for? slow moving things like conveyors and such but not for? high speed use.? The best material f or a thrust washer is modibdinum filled 12 ¨C 12 nylon. ? Dennis ? Sent from for Windows 10 ? From: L Leonard via groups.io
Sent: Tuesday, August 11, 2020 4:49 PM To: [email protected] Subject: [DaltonLathes] hrust bearing ? I await my belts for the old/new lot 4 #2050.This week end! ? |
