开云体育

Please let us know. I’m always eager to learn!

Charlie. Luckily I only have 2 choices! Pretty sure it's the speaker and not my top shelf soldering abilities! Lol...thanks man! [email protected]> wrote:

That is the process I just used to fix my sprinkler system and it will work, especially if you have known good parts readily at hand to swap / sub. However, if you have multiple failures, like I did,

Richard..exactly. would definitely narrow it down. <richardadelberg@...> wrote:

You could swap the mid range driver from one speaker to the other. This would narrow it down to driver or crossover [email protected]> wrote:

If it started doing this after recapping I would suspect the solder joints. Do both speakers do this? Did you replace the components individually? Any chance the caps got interchanged with wrong

Thanks. They look great!?

wrote:

Well Johnny...there's the twist! I didn't follow due diligence when I purchased. It had non Advent speakers installed. But....from what I've heard from the original 10's with Masonite they are at

Mickey - what difference (if any) did you notice about the Advent 12's vs the original DQ20 woofers?Thanks,Johnny

I just recapped my 20's recently but didn't replace the cement resistors. I have a slight crackling in the mid Magnat even at low volume..and it seems appears on different music tracks. Weird right!

I'll testify to Simply Speakers Advent 12's I just installed in my 20's (I had no choice to rebuild.) And they sound fantastic. The fit was exact with mounting screws. Purists cover your eyes!! No but

My original 'Advent' woofers were stolen, or too far gone . . . I replaced them with Simply Speaker 12"ers and they are just fine. I know originality is a good thing, but just sayin' . . . it is hard

If you're not a DIY person, this is where I'd send speakers http://www.millersound.net/

Some good news. ?Removed the woofer last night and found the voice coil slightly rubbing. ?On closer inspection I discovered that the glue holding the surround had let go in several places. ?Should

if you’re sure the distortion is coming from the woofer sounds like a replacement is in order.

No popping sound before I noticed distortion.? I did to 180 degree rotation and was unsuccessful in solving the distortion.

Ed when in circuit that is about right and indicates the resistors are probably OK. The voice coil should also not be melted. Still could be mis centering or voice coil deformation. Did the speaker

I have a set of original yellow cap xo’s in storage. I’m not sure what’s going on with your xo ‘s, but the lQQk a mess with wires cut and bridged . I’m sure you know that some of the cap

Charlie, thanks the suggestion. ?A quick measurement of the 4ohm resistors shows 2.9 ohms each. ?I do have a left and right sub, but unfortunately at some point decided to send full range from the