开云体育

If you want to test your hypothesis, right click on one of the spots you think should not show and choose "Display spots of (call) near (freq) in (mode)" and the popup will show all of the spots. The

The reason you don't hear a spotted station may have to do with propagation or may also be due to you just getting there too late. Sometimes a station calls CQ once or twice and is spotted but

I have Origin set for NA-E and NA-W, but I am still receiving a lot of spots originating from EU and SA. It is because somebody in NA-E or NA-W spotted them earlier I am assuming. I sometimes don't

I installed build 14271 on my laptop yesterday afternoon. All seemed well except for some nasty changes they made to the system tray. I did not try DXLab until seeing your report just now. I

Just downloaded Windows 10 build 14271. NO DDE AGAIN!... KJ1J

I reported a few weeks back that sometimes DXKeper does not know that Pathfinder has started. The exact symptom was that entering a callsign in the Capture window and striking <enter> did not cause a

Anyone one with ideas where to look to solve the fact that I am able to achieve PTT with Commander and Winwarbler for PSK but not for RTTY. Click on "start" in PSK caused the Flex 3000 to trnsmit but

Thanks for the very fast response Dave, That's just what I was looking for. OK, back in my hole, Ron, KU7Y Arizona Outlaws Contest Club Northern California Contest Club Silver Springs,

-----Original Message----- Sent: Wednesday, February 24, 2016 8:00 PM To: dxlab@... Subject: [dxlab] Band data output? I've looked through the "manual" but can't find what I'm looking

-----Original Message----- Sent: Wednesday, February 24, 2016 9:28 PM To: ' Dave AA6YQ' aa6yq@... [dxlab] Subject: [dxlab] DXCC Mismatches and etc I am finally getting around to getting

-----Original Message----- Sent: Wednesday, February 24, 2016 6:57 PM To: dxlab Subject: Re: [dxlab] Spot Collector suggestion

I am finally getting around to getting caught up... I just ran some of the reports, updates and etc... Here are my questions... I know when I go to DXCC Credits Granted, I see some dupes. How do I

I've looked through the "manual" but can't find what I'm looking for. Does any of the DX Lab programs send the band data to the parallel port? Pins 2, 7, 8 and 9 are the 4 BCD output pins and pin 18

[dxlab] <dxlab@...> wrote: Agreed. IMO, from a UI perspective, the ideal behaviour would be that each invocation of "Display spots of..." would create a n

-----Original Message----- Sent: Wednesday, February 24, 2016 12:43 PM To: dxlab@... Subject: Re: [dxlab] Spot Collector suggestion If that has too high of cost/benefit ratio, how about

I'm ambivalent on this capability. However if it is useful to others I wouldn't deny them its utility. Even though I have three monitors and the main monitor is 2560 x 1440 pixels, I wouldn't use it

Thanks Dave. I knew it was there somewhere. Just didn't know how to find it. I have now bookmarked that page in my browser. Randy - AJ7B

To ensure that you are connected to the cluster (as requested by Cluster operators), SpotCollector looks for <yourcall> de X where <yourcall> is the Username you've specified on the

OK, so ... SpotCollector has some specific expectations about the command prompt provided by the cluster node, and won't consider you "connected" until it sees that. Dave will have to give you exact

It is the CDXC cluster at:- cluster.cdxc.org.uk - port 7300 log in is callsign but it is password protected. I have just checked the CDXC website to make sure that the details are correct & they