开云体育

Thank you, Dave. IC-PW1 address at 74(DXLab's “Controlling an Icom PW1 Amplifier” instructs to set the address of IC-PW1 to 74.). IC-7600 address at 7A. IC-7600 controls IC-PW1

Leave the PW1 address at 71 and the 7600 address at 7A. Your serial number is high enough to allow standby pass through. Let’s try this again step by step. To ignore the computer and DXLab,

LotW does not accept "QSOs" made on the internet. If you QSOs are truly internet QSOs you can not upload them. If they are not "internet" QSOs, correct the Mode in the Propagation panel of the Log

When I submit most requested I get a blank window. If I try to upload manually I get a message that no QSO's were submitted because some QSO's were already uploaded or invalid. Of course checking Lotw

+# More AA6YQ comments below # A grid square determined by "geocoding" means that the grid square was "determined" from a postal address; I've appended Perplexity's explanation of this process below.

Thank you, Dave. Vic

+ AA6YQ comments below

Dave/all Using DXKeeper 17.9.9 I have imported an .adif log using the procedure here: https://www.dxlabsuite.com/dxkeeper/Help/Import.htm I have checked, in the upper left of the ImportQSOs tab

PC Start ?Regulated Power Supply?IC-7600 ?Start DXLabCommander This should work since the "COM" port for the IC-7600 will be present by the time Commander attempts to access it. If you are

Double clicking a call in SpotCollector with a prefix/call sign eg. FY/X8WW shows up in the DXKeeper filter box as X8WW but.... does show up in Capture as FY/X8WW with the prefix DXCC (FY) and is

Regarding "distance", qrz provides the input for this set of procedures in DXKeeper https://www.dxlabsuite.com/dxlabwiki/QSODistance -- Mike KM2B

Anyone that can afford a reasonable HF station these days can afford QRZ. It is far more up to date and has far more information than the old days of the callbook. That book and or CDs if adjusted

" All of the above information emits from a xml data query made by DXKeeper and all for some tiny payment. " OK, my apology:? The xml query delivers the Operator Name, QTH, Grid Square and

One use case, of mine, might be of interest to you regarding QRZ.com "xml data subscription". First, I use DXKeeper for my logbook.? Which enables me to set specific fields of interest for display

+ AA6YQ comments below I received the following resposnse from LoTW after giving it a Sync LoTW QSOs button press: Date Time Call Band Mode Submode

Dave, W6DE I do not see where you turn on your computer. + Power is turned on in this order. Regulated Power Supply?IC-7600?PC?Start DXLabCommander （IC-7600 and DXLabCommander work

I received the following resposnse from LoTW after giving it a *Sync LoTW QSOs button* press: I checked the log, and that QSO was in doubt, and I had confirmed a QSO with that station about 7 hours

I do not see where you turn on your computer. In addition, you say you are turning on and off your 7600 power. Do not turn on or off your 7600 with the switch on your power supply. Turn on your

Dave, I did resolve the problem. I will send you an email, because I didn't the person who assisted me permission to post his solution on the forum. Roland NA5Q

+ AA6YQ comments below Craig, Dave, the request for an enhanced QSO Path in DX Atlas is of serious interest here. I would encourage an improvement at your own convenience (of course) if this is