开云体育

AHA! OK, I think I have it. I just had a great example. 2 spots for VK9XU on 28.095. One is black and one is red. the black one is FT8 and the red one is RTTY When I check the award status the

Hi Dave, I realize that. But it's being flagged red even though I've already worked it on one of the other digital modes. This isn't happening in reverse. I've seen spots for FT8 stations that I

To answer Joe, I have SC Filter selected and nothing is in it. I think what I wanted to try was unclear. I'll try to describe it better. It's not that I don't want to see the spots that come in as

Hi Dave & Joe, To answer Joe, I have SC Filter selected and nothing is in it. I think what I wanted to try was unclear. I'll try to describe it better. It's not that I don't want to see the spots

Perhaps the OP made a typo and meant FT8 rather than FT9? JT65 and JT9 were popular JT modes when I became a ham 10 years ago. 73 Stan KM4HQE

Don, Are you using a filter in Commander -> Config -> BandSpread -> Spot Filter? If so, which filter and what is in it? I'd bet you have defined one that specifies Mode='RTTY' ... you will want to

+ AA6YQ comments below Currently my bandspread will highlight anything I need on RTTY. I don't use RTTY anymore and primarily use FT8 as my digital mode. Is there a way to get the bandspread to

Thanks Joe, That appears to also work. Jim - KR9U

Hi Dave, Currently my bandspread will highlight anything I need on RTTY. I don't use RTTY anymore and primarily use FT8 as my digital mode. Is there a way to get the bandspread to only highlight

Jim, try working from the other direction: Set/DX/Filter NOT CTY=K 73, ... Joe, W4TV

Thanks Dave, That will certainly help. Jim - KR9U

+ AA6YQ comments below Many times, especially during contests, I filter spots at the DX Cluster. One of the commands that ARCluster accepts if you want to only see non-US spots is the command:

The "bad spotter" problem should be cured now. Here are K9IMM's responses to a 6-meter group:

Well I am not sure what I did or what happened but the selection for Spectrum-Waterfall Display is no longer grayed out.

I think I got tripped by the AI word changer. I wondered whether you meant JT9 instead of FT9? Rich, NU6T [email protected]> wrote:

FT9? OR FT9? Rich, NU6T [email protected]> wrote:

Regarding DX Atlas not working with DX View...? This morning it's working - Version 2.41.? Must be your magic, Dave.? Thanks. -- Bruce - W4NDX

Thanks all; Joe, I think you are correct (I misremembered JT9 and called it FT9). 73 de Dave, W5SV

You might sort by frequency instead of band. Vy 7 3 Earl / KD5XB DM84 e e Sent with [Proton Mail](https://proton.me/mail/home) secure email.

Thanks so much Joe for the guidance. This is exactly what I needed. I did run my file through the AC1D converter prior to importing so for whatever reason those 2 callsigns weren't corrected.