开云体育

When I use the 'Sync All" button on the QSL tab the resulting date and time of the LOTW QSL and QSO sync does not update to the same. The resulting report says that both were updated together. If I do

+ AA6YQ comments below Yes I get the same behavior - I hadn't tried this before. If I double click on the tiny window the normal size window pops up with the status bar as before. It must be a

There have been discussions in this group about the 13 character limitation. The supported maximum callsign length can vary in Amateur Radio software.? However, there are known callsigns (with and

Thanks Larry for taking the time to explain this to me…we will take a look at doing it this way. Mark WC3W

Mark, You said: "I have configured the General Tab within Commander Configuration with the IP Address of my home computer, and listed the IP Port as 4992." If you operate remote this won’t work

I use a program called syncback from https://www.2brightsparks.com/ They even have a free version which will do just fine for what most need. mine is set to back up my log every hour, so unless i am

When using DXView World Map the WSJTX FT8 qso path is plotted correctly;y. If i enable DX Atlas map instead of the World Map, the qso path is not plotted. Is it possible to have the qso path shown in

Don, Just don’t forget to periodically go back and delete some of the older backups. Bruce McLain bruce.mclain@...

The problem has been fixed by installing an updated version of DX Atlas. V2.41 73 Paul w2eck

Good idea Bruce, I turned that on as well. As a former systems analyst I'm kind of kicking myself. One of my primary jobs was to write code to backup headend unix servers and verify them for

Larry, thanks for your tip…if we cannot get it to work as we had before, this will b a fall back position. BTW, SmartLink should have nothing to and should not prevent us from connecting Commander

Dave, This is an alternative method that uses Flex SmartSDR CAT and is therefore more secure. 73, Larry KB1VFU

DXKeeper can automatically backup your log on shutdown. That won’t protect from a spontaneous PC reboot but at least you would have a backup from the last DXKeeper shutdown which might minimize the

Problem solved.? Pilot error (as usual).? Sri for take up the bandwidth. Dale

Correction - My custom filters for stuff like just CW or just 160 or just 160CW show the spot but the filter for DXCC with the filter box showing YB shows a bunch of YB spots but not this needed

This morning a spot showed up for YB1JCD on 160 CW on SC.? In the Needed column the spot showed a D which agrees with what DXView shows for YB Progress (DXV shows no QSO's on 160 in any mode for

It has happened to me with Windows 10. 73, Rich VE3KI

Yes I get the same behavior - I hadn't tried this before. If I double click on the tiny window the normal size window pops up with the status bar as before. It must be a Windows 11

+ AA6YQ comments below + SpotCollector accepts the WWV "readings" it receives from your spot sources. 73, Dave, AA6YQ

+ AA6YQ comments below + Are you referring to the configuration you described in this article, Larry? https://www.dxlabsuite.com/dxlabwiki/RemoteControlFlexSignature 73, Dave, AA6YQ