开云体育

Frequency info as configured on the device tab. I'd like to use it not only to control remote antenna switches but also remote matching networks.

+ AA6YQ comments below I'm building a wireless antenna control switch and I was wondering if there is a method for sending AUX info over the UDP Network Service. + What is "AUX info" in this

On 20/06/2020 17:35, Rick Boswell wrote: > > Relative newbie here to DXL/WW/7610/RTTY. Have been using this combo for about 18 months and slowly developing modest competence with a small subset of

Hi RIck. If your radio has a USB port like the IC-7300 and many others. You can just use a USB cable.? You also have to install the drivers for the sound card. If you want to use FSK,? then you

Relative newbie here to DXL/WW/7610/RTTY. Have been using this combo for about 18 months and slowly developing modest competence with a small subset of overall capabilities. Have had digital modes

Dave: I'm building a wireless antenna control switch and I was wondering if there is a method for sending AUX info over the UDP Network Service. If not, is this something that could be implemented?

Dave, you must be reading my mind.. when I was first getting my TS440s working on FT8 I had it successfully configured the way you suggested but not on the same computer that I've been experimenting

+ AA6YQ comments below I operated portable from KP2.....as KP2/WW3S.....do I need to request a separate certificate + Yes, because KP2 is not in the same DXCC entity as WW3S. You'll also need a

You need a separate certificate for every call sign you use. You can request a certificate for the KP2/WW3S call sign using the certificate for WW3S as authentication. 73, Rich VE3KI

+ AA6YQ comments below Thanks Dave, I had a feeling that I was attempting something that isn't possible, now I understand more the "why not" thanks to your clear explanation. I will say that I

I operated portable from KP2.....as KP2/WW3S.....do I need to request a separate certificate, or do I assign a separate station location under my regular call?

Thanks Dave, I had a feeling that I was attempting something that isn't possible, now I understand more the "why not" thanks to your clear explanation. I will say that I learned a lot more about

+ AA6YQ comments below I may be trying to do something that isn't possible, or more likely I am missing something in my configuration/setup. I've spent quite a number of hours looking through

Problem resolved Dave, had a Windows update and for some unknown reason it resolved the isue Wayne VK4WTN

I may be trying to do something that isn't possible, or more likely I am missing something in my configuration/setup. I've spent quite a number of hours looking through documentation, help texts,

Think I replied privately by mistake. Tnx for the info, Joe. The tech had me run that yesterday, and while it did find errors, and supposedly fixed them, it didn't solve the original problem. Just

??? Thanks for the reply Joe. That was one of the processes the MS tech tried. The scan said it found errors and fixed them, but it didn't fix the problem. Probably can't hurt to do it again. Worse

Dave, you might want to try dropping to an elevated command prompt and run: SFC /SCANNOW It's possible you have a corrupted Windows file and this will find and fix those.? I also had to back out of

+ AA6YQ comments below First on windows 10 with auto update off. A couple of days ago Commander does not connect at startup. I am using the multi radio tab with SATpc32, an IC-9700 and a Flex

+ AA6YQ comments below The band map followed the radio closer, when tuning from the radio, and the radio and commander followed faster when clicking on the band map. There was not much difference,