开云体育

Mark, Using SmartSDR CAT to obtain band data is secure via SmartLink? for remote ops, while port forwarding is by default insecure as the open port is not protected. However, you can configure your

Larry, after reading this I think I failed to mention to you that we actually have a VPN in place between home and remote site…so the router does not need any port forwarding. We now have

+ AA6YQ comments below + It's new for Paul W2ECK, as he reported in /g/DXLab/message/227832 73, Dave, AA6YQ

2.41 is not a new version, it was released a year ago. Alex

+ AA6YQ comments below When using DXView World Map the WSJTX FT8 qso path is plotted correctly. If i enable DX Atlas map instead of the World Map, the qso path is not plotted. Is it possible to have

+ AA6YQ comments below + The dates shown beneath the "Sync LoTW QSOs" and "Sync LoTW QSLs" buttons are unrelated: + The date shown beneath the "Sync LoTW QSOs" button is the date on which LoTW last

When I use the 'Sync All" button on the QSL tab the resulting date and time of the LOTW QSL and QSO sync does not update to the same. The resulting report says that both were updated together. If I do

+ AA6YQ comments below Yes I get the same behavior - I hadn't tried this before. If I double click on the tiny window the normal size window pops up with the status bar as before. It must be a

There have been discussions in this group about the 13 character limitation. The supported maximum callsign length can vary in Amateur Radio software.? However, there are known callsigns (with and

Thanks Larry for taking the time to explain this to me…we will take a look at doing it this way. Mark WC3W

Mark, You said: "I have configured the General Tab within Commander Configuration with the IP Address of my home computer, and listed the IP Port as 4992." If you operate remote this won’t work

I use a program called syncback from https://www.2brightsparks.com/ They even have a free version which will do just fine for what most need. mine is set to back up my log every hour, so unless i am

When using DXView World Map the WSJTX FT8 qso path is plotted correctly;y. If i enable DX Atlas map instead of the World Map, the qso path is not plotted. Is it possible to have the qso path shown in

Don, Just don’t forget to periodically go back and delete some of the older backups. Bruce McLain bruce.mclain@...

The problem has been fixed by installing an updated version of DX Atlas. V2.41 73 Paul w2eck

Good idea Bruce, I turned that on as well. As a former systems analyst I'm kind of kicking myself. One of my primary jobs was to write code to backup headend unix servers and verify them for

Larry, thanks for your tip…if we cannot get it to work as we had before, this will b a fall back position. BTW, SmartLink should have nothing to and should not prevent us from connecting Commander

Dave, This is an alternative method that uses Flex SmartSDR CAT and is therefore more secure. 73, Larry KB1VFU

DXKeeper can automatically backup your log on shutdown. That won’t protect from a spontaneous PC reboot but at least you would have a backup from the last DXKeeper shutdown which might minimize the

Problem solved.? Pilot error (as usual).? Sri for take up the bandwidth. Dale